Jump to content

bad bounce while towing

rusty01

By rusty01
in Towing, Hauling & Hitches

Recommended Posts

rusty01 Enthusiast

rusty01

Posted
Posted

I have been noticing a bad bounce when going over bumps when towing the TT. I had new shocks installed on the rear but that did nothing to remedy the issue. I did not replace the front shocks yet. Could those be the culprit? It almost feels like the camper is "pushing" down and forward while going over bumps. Truck and camper are in my sig. Any other info to help rememdy this would be helpful! Thanks!

  • Replies 76
  • Created
  • Last Reply
00Silverado4x4 Senior Enthusiast

00Silverado4x4

Posted
Posted

Definitely get your front shocks done so you can hopefully discount that possible problem. Double check your trailer brakes to ensure they are both working the are providing enough stopping power. Also make sure you have the trailer loaded so that you have approx. 10-15% weight on the tongue. This will help prevent sway and provides better control of the trailer while driving. Lastly take a look at your equilizer bars, making sure you are putting too much/little weight distribution between your truck and trailer. If this all sounds like Greek take your truck/trailer combo, while loaded as you would be going camping, to a camper/travel trailer dealer and have them go over your rig to double check all settings and adjustments.

nht mike Enthusiast

nht mike

Posted
Posted

Sounds like you may not have heavy enough hitch bars. Weigh the tongue then make sure your bars are rated heigher than that. With the correct bars and hitch setting, the steer axle should have 5 to 10% of the tongue weight on it.

 

Mike

Blue2500CC Enthusiast

Blue2500CC

Posted
Posted

Did you try changing your speed while you were feeling the truck/trailer "bounce"? While it sounds like you may need higher rated bars, it is possible you were feeling "porpoising" due to road conditions.

 

As for how much weight to transfer to the trucks front axle, some now say to only transfer enough so the the front tow vehicle (tv) wheels weigh the same unhooked (no trailer at all) and hooked up, bars latched ready to go.

 

BUT... others, like Mike, like to transfer a little more weight to the front than when unhooked.

 

Which way is correct is the million $ question!

 

When I set up my 2k Chevy ECSB 4x4 I transfered almost enough weight to the front so there was almost equal drop front & rear. This was before I learned about actually weighing the truck/trailer combo at the CAT scales. I set up my new truck by transfering enough weight so the front axle weighs almost the same as unhooked. I am still trying to fine tune it though!

 

Good luck!!!! & keep us posted!!!

Chris

 

brainpause Enthusiast

brainpause

Posted
Posted

Did you try changing your speed while you were feeling the truck/trailer "bounce"? While it sounds like you may need higher rated bars, it is possible you were feeling "porpoising" due to road conditions.

 

As for how much weight to transfer to the trucks front axle, some now say to only transfer enough so the the front tow vehicle (tv) wheels weigh the same unhooked (no trailer at all) and hooked up, bars latched ready to go.

 

BUT... others, like Mike, like to transfer a little more weight to the front than when unhooked.

 

Which way is correct is the million $ question!

 

When I set up my 2k Chevy ECSB 4x4 I transfered almost enough weight to the front so there was almost equal drop front & rear. This was before I learned about actually weighing the truck/trailer combo at the CAT scales. I set up my new truck by transfering enough weight so the front axle weighs almost the same as unhooked. I am still trying to fine tune it though!

 

Good luck!!!! & keep us posted!!!

Chris

 

 

Well said, as other input.

 

Porpoising was my first thought, especially if you were experiencing this on a concrete highway. Seems that many times the sections of concrete match the resonant frequency of the combo. If you are going just the right speed, it will jar your liver. In those cases, there is often nothing wrong with the setup; you'll just need to vary your speed.

 

I tinkered with my setup so much that I tired of it. I even went to both extremes. Once I even had so much weight shifted forward, off the rear tires, that a simple, slow launch resulted in spinning tires on dry pavement!

 

Ultimately, IIRC, I got just a little more weight on steer axle than empty. Works well. I've got my Cat Scale sheet scanned. I'll try to post it tomorrow.

Z45 Senior Enthusiast

Z45

Posted
Posted

Your rear springs are not up to the job, too much weight. And like was said, you are pushing the limits of a 1500 with that size trailer IMO.

rusty01 Enthusiast

rusty01

Posted
  • Author
Posted

OK, I understand that the trailer is almost too much for my 1500, I get that. I knew that before I bought the trailer. I did install some Monroe Sensatrac coil overs in the rear. Didn't seem to help any. I did try and vary my speed but didn't seem to help. I wonder if maybe I do have too much WD to the front. I guess I will have to mess around with bar placement and see what happens. I am getting new shocks installed on the front, Monroe Reflex monos. I do hope it's just due to bad front shocks but the way it acts I am guessing that will not totally fix it. Might help a little though guess I'll find out.

rusty01 Enthusiast

rusty01

Posted
  • Author
Posted

Get a bigger truck

 

 

You gonna buy it for me?? Duh, of course that would be the best option but since I am a poor Michigan worker, I gotta use my ol rusty pickup! lol

00Silverado4x4 Senior Enthusiast

00Silverado4x4

Posted
Posted

Just to back up a bit, what are your official weights on this trailer? Take it to a certified weight scale and get your true empty (dry) weight, tongue weight and rear axle(s) weight. Then do the same for loaded. Then with loaded with the truck (also loaded). I am a curious type person and would like to see what your actual numbers on this truck/trailer combo. Yeah you "might" be overloading but then again maybe not, after all trailer size isn't the real issue as trailer weight is what is going to be the problem here.

pwall Senior Enthusiast

pwall

Posted
Posted

Looking at a website for the trailer, it's listed at 6890lbs dry, so the GVWR is most likely close to 9000lbs.

What I see on the website is that they're listing the hitch weight at 3010lbs, that can't be right. I would suggest to get the trailer weighed, and have the tongue weight weighed as well. Then you'll be able to make a more of an informed decision on what might need to be done to your tow vehicle to support it.

What is the exact model you have ?

rusty01 Enthusiast

rusty01

Posted
  • Author
Posted

Yellow sticker on door of trailer list 6298# dry. Listed dry weight online lists base weight of 5590# and hitch weight of 740#. GVWR on trailer is 7600#. I do not have a convient way to weigh the trailer as there are no cat scales close to me. Just going off what is listed on the trailer itself and my onwers manual of my truck. I do know we pack rather light with just minimal things needed for camping.

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • Coastie05
      Replacing 2.7L on 2021 Silverado with 2023 2.7L

      By Coastie05 · Posted

      I’m definitely interested to hear the end result here. 
    • MASONV88888888
      Another 6.2L engine failure!

      By MASONV88888888 · Posted

      My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • MASONV88888888
      Rattle in the rear!

      By MASONV88888888 · Posted

      Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • Buckwild27
      Gas Prices

      By Buckwild27 · Posted

      I have 2 choices. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...