Jump to content

Recommended Posts

Posted

I wasn't even towing and as I was coming to the bottom of the Ben Franklin Bridge I looked at the DIC and saw "Grade Brakjng Activated", not sure why.

Posted (edited)
On 7/9/2019 at 10:20 AM, Brummie99 said:

While towing my new travel trailer last week, slowing down for a turn, slight downhill but not braking, the truck suddenly down-shifted and revs went up to 5,000+.

 

Looked down and the DIC said "Grade braking activated". Cool! I thought that was only on diesels.

 

EXHAUST braking is only on diesels.  All the new GM trucks have GRADE braking.  It works differently between "regular" mode and Tow/Haul mode.  You can also turn it off if you don't like it but you need to do it each time the truck is started.

 

The operation of it is explained in the owners manual ...

Edited by sk
  • Like 2
  • txab changed the title to Discovered! Features you may not have known about...
Posted

I apologize in advance if this is a duplication but when I get a phone call on my paired Samsung Note 8, it displays the phones' battery status and signal strength on the screen. :)

  • Like 1
Posted
13 hours ago, Flinthills said:

I apologize in advance if this is a duplication but when I get a phone call on my paired Samsung Note 8, it displays the phones' battery status and signal strength on the screen. :)

Just noticed that yesterday on mine...

Posted

MY 18 displays the phone vitals and Wi-Fi strength in the top left hand corner of the nav/radio screen at all times.

  • Like 2
Posted

Likewise when connected via CarPlay. But it’s different on the intellink screens vs when you’re in the car play screens. Like in intellink it shows battery life, on CarPlay it only shows signal strength and data type at the left side above the home button:

21ab5989f73509ad33fb45609677b872.jpg

 

 

Sent from my iPhone using Tapatalk

 

Posted
1 minute ago, slide187 said:

Likewise when connected via CarPlay.


Sent from my iPhone using Tapatalk

Don't use Car Play, just connected with Bluetooth.

 

Think this feature started with the introduction of Wi-Fi in the trucks.

Posted

When traveling with my dogs, I always put them in the bed. I have a rubber mat on the floor to keep them from sliding around and have a topper on it. I have the sliding rear window on the cab and the windows are tinted. I usually have the slider opened as well as front window on the topper so I can try to keep an eye on them. Besides the bed lights, I have a dome light on the topper that is hooked up via the bed lights. At night, especially with the tinted cab sliding window, it is very hard to see what they are doing back there. I knew that while moving, just pushing the cargo light switch wouldnt work. Just for kicks, I tried switching into neutral while rolling down the road, and sure enough, the bed lights and topper dome light came on. Now I can check on them any time I want at night.

  • Like 2
Posted
6 hours ago, mikeyk101 said:

When traveling with my dogs, I always put them in the bed. I have a rubber mat on the floor to keep them from sliding around and have a topper on it. I have the sliding rear window on the cab and the windows are tinted. I usually have the slider opened as well as front window on the topper so I can try to keep an eye on them. Besides the bed lights, I have a dome light on the topper that is hooked up via the bed lights. At night, especially with the tinted cab sliding window, it is very hard to see what they are doing back there. I knew that while moving, just pushing the cargo light switch wouldnt work. Just for kicks, I tried switching into neutral while rolling down the road, and sure enough, the bed lights and topper dome light came on. Now I can check on them any time I want at night.

 

The bed lights don't work while in gear?  Weird.  

Posted
4 minutes ago, Nick The Great said:

 

The bed lights don't work while in gear?  Weird.  

Thought about that… Probably to keep the overhead centermounted cab high light from shining in the faces of drivers behind you.

Posted

Good to know, when someone comes up behind me with their high beams on I turn on the cargo lamp. Worked great in my 2001 Sierra, didn't know it was disabled in the newer ones.

Posted

This is one I got from @pgamboa

How to swap the glovebox lock for anybody doing the whole dash swap on a 2014-18 Chevy or gmc there a small notch when u pull the lever down on the glove box u needa a small screwdriver or something thin to push it down and pop it out the cylinder hole, it’s a small silver/chrome piece holding the lock n the cylinder!!!! 

  • Like 1
Posted

Today, I remote started my ‘15. 

 

It wasn't until I unlocked the doors, got in, turned the key and shifted to drive that I was alerted the right rear door wasn’t fully closed. 

 

I didn’t think it would start under that circumstance. 

  • 2 weeks later...
Posted

Navigation top green icon on radio screen changes with direction. 

 

I always payed attention to the cluster and after 1.5 year of ownership just noticed it changes on radio screen as well. 

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Congratulations Isttype, on your gmc. Really like my 2024 2500hd sle doublecab now with 85,500 miles.  I checked the oil today at 4800 miles since last oil change and barely reading on the stick.  I don't care if GM says it's Acceptable adding a quart every 2000 miles because that is 100% BS, It is not a 1966 Harley Shovelhead! Sounds like it's setting up a future failure like I had with my 1500 6.2l. Other than oil consumption problems, I really like the 6.6l gas and 10 speed is really nice.  Towed a light 4000 pound trailer last week and averaged 14 mpg.  I was pretty impressive that a 7300 pound gas truck did 14mpg towing, Later-
    • Long Term Cold Cycle Limited Testing   Back to the 1990's and XOM's million mile test. Since then there have been others and there will be more. Schaeffer's, AMSOIL to name two. Of these Schaeffer's is the stand alone which I will explain in a bit later.    http://papers.sae.org/600190/:   http://papers.sae.org/850215/:   Up to 75% of  engine wear occurs on cold starts. These two links (above) provide the technical reasons for engine wear. In a nut shell, and by a large margin, cylinder wear is what takes out most motors and even with a pre-oiling system that part of the engine is dry enough on cold starts and cold warm up to pierce Stribeck.   So when you put a motor, or a car, on a dyno for a million miles stopping only for oil changes, (yes fuel is uninterrupted) or break down maintenance, you are depriving the test of the most important part of it's wear cycle. Yes a million is then a pretty easy walk even for a mineral oil under those conditions.    How about cleanliness during the long test cycles? Same thing. Varnishes that stick rings and insulate parts are laid down by repetitive 'heat cycles'. It's the cool down the precipitates the varnishes. These long runs also hinder acidic attack caused by cold start richness and less than optimal cold start ring sealing. They hinder water formation and enhance breathing of the crankcase; the petri dish of acid formation, the first step in sludge formation, amalgamation and precipitation. These motors are also monitored and controlled for water and oil temperatures to within the "normal operating range".      https://www.swri.org/sites/default/files/sequence-iiih-test.pdf Note the test sequence in some boutique oils literature for testing, API IIIH, is not the standard used for the ILSAC G7 testing. Does that mean it is irrelevant? No, not as used. As used as a 'visual guide' it makes it's point. The G7 weighted piston deposit minimum is lower.      Back to Schaeffer's. That was a cyclical test of an engine in fleet service and not a dyno mule and if you saw the video it was not mirror clean but wear was low.    There are oils like BioSyn and other 'Renewable" source oils that taught cleanliness and have proven themselves in fleet testing. Havoline an other example.    The newest ILSAC G-7 test prioritize cleanliness, LSPI mitigation and fuel economy OVER WEAR. In comparison Porsche C30 Specification Verses ILSAC G-7 Specification below:      Some will balk that this graph isn't apples to apples and I will challenge that in that this graph represent the SPECIFICATION and not the any One Oil Performance.   It is absolutely possible to minimize wear, maximize cleanliness and mitigate LSPI etc., It just isn't cheap and currently I see none that are not walking toward profit over performance.     
    • I don't think you will need a split, separate product, etc., the OBD port should be able to deliver everything you need. Since your device would be plugged into it all the time, it wouldn't miss anything.    Hardware in this case will be the easiest part of your project - ELM 327 devices will already deliver all the data you need. Reporting/software is where your advantage/marketability is.
    • I do too. I’ll never be stuck again 😂
    • It has happened to me a few times. I carry a jumpstart-tire inflator with me.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...