Jump to content

Recommended Posts

Posted

the reset has been working for me for 8 days now.  This was hard reset including user settings.

 

Thanks all.

Posted
On 5/17/2021 at 9:58 PM, sobby said:

I have the same problem. Pain in the ass.

Sobby

The radio reset works

I did mine weeks ago and it is working fine.

Others have done the same

Posted

I have a 21 Silverado custom trail boss and have the same issue! Driving me nuts!!!!

Posted

I have a 2021 Elevation with this problem. It seems that most times it's using the remote that causes this. I have had 2 remote start failures as well. 

 

I have also noticed that it will not be able to find the content on a USB stick sometimes. Also the USB port can get extreamly hot when using a USB stick (32 GB if that matters).

 

I am taking it to the dealer next week.

Posted

not only does my equalizer go back to 0 but the maximum startup volume goes back to 0 and the audio feedback changes, auto volume goes back to none........ this is on a 2021 infotainment 3 system.

Posted
Quote
On 4/30/2021 at 5:38 PM, Random said:

These are the steps I followed to reset the radio in my truck:

1) Browse the radio menu's to Settings > System > Return to Factory Settings

2) Select Reset Vehicle Settings

3) Wait to reset

4) Select Erase Settings and Personal Data

5) Profit

 

I reset my radio on 4/16/21 and I haven't had a problem since.

 

Reset worked for me.

Levels have not reverted back to 0 since performing factory setting reset (almost 3 weeks). Simple "fix" for an annoying issue. 

  • 2 weeks later...
Posted (edited)

Good morning all,

 

I work in the Service Department at a GM Dealer. We have a customer with this same concern and as of April 20th, GM Technical Assistance made us change the radio and it failed.

 

As of May 7, 2021 they released a Document (PIT5839A) that describes your exact concern. It is currently under investigation by engineering looking for a permanent solution.

 

GM requires us to verify the radio software is version V135118 (the problem only occurs with that software). If so it is requiring you to perform a radio reset by selecting “Erase settings and personal data” under the “Restore to factory settings.” 
 

They do inform us this may only be a temporary solution; thus GM looking for the root cause.

 

Will keep ya updated.

Edited by MattWyatt69
  • Like 1
Posted
57 minutes ago, MattWyatt69 said:

Good morning all,

 

I work in the Service Department at a GM Dealer. We have a customer with this same concern and as of April 20th, GM Technical Assistance made us change the radio and it failed.

 

As of May 7, 2022 they released a Document (PIT5839A) that describes your exact concern. It is currently under investigation by engineering looking for a permanent solution.

 

GM requires us to verify the radio software is version V135118 (the problem only occurs with that software). If so it is requiring you to perform a radio reset by selecting “Erase settings and personal data” under the “Restore to factory settings.” 
 

They do inform us this may only be a temporary solution; thus GM looking for the root cause.

 

Will keep ya updated.

 

Thanks for the info and "Welcome" to the forum!

  • 2 weeks later...
Posted

I have a 2021 Trailboss custom and same issue here, I'm losing my equalizer settings everytime I shut the truck off, my dealer said they haven't heard of this issue, I can't find the (user profile) to see if the dealership set it up but my truck is just the basic model, does or has anybody figured this problem out yet?

  • 3 weeks later...
Posted

had the same problem with my 2021 silverado custom so I went to the dealership and they did a flash upgrade of the infotainment software.....problem solved!

  • 1 month later...
Posted

I did a factory reset and have not had any issues in 3 weeks.  The dealership was confused by this working but was aware it was a problem.  Told me GM was working on the issue and trying to get a new software fix out there.  I think their resources could have been better spent on just letting the dealership know that a factory reset of the radio fixes the issue.

  • 2 weeks later...
Posted

I have a 2021 Silverado 1500 RST Crew cab but I have the basic radio option in it, so no profiles.  I have to set the equalizer every time I get in it. I noticed that when you’re in the equalizer settings, there is no “save” button after you’ve made the changes. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Any joy with this truck seems to be short-lived.   The CEL for P0172 ("bank 1" too rich) is now "intermittent".   I'm not sure where to check, or re-check, and my energy to keep chasing problems with junk is wearing thin. The P0172 seems to set as I'm coming to a stop, completely off the throttle, when fully warm. At least, that's what it's done the 3? times it's set.   Everything appears normal on the scanner EXCEPT long term fuel trim. There's only one bank on this vehicle because it's an OBD 1.5 with only one upstream O2 sensor. At idle, it's around -16.4% and will dip to -18% occasionally at idle or off-throttle. LTFT approaches 0 when throttle is held at 2500rpm. Short term appears normal, much closer to zero all the time. The LTFT tells me the engine is running rich at idle but compensating at higher load. But, why?   The EVAP purge valve doesn't appear to be leaking/sucking fuel vapor continuously. Is it sticking just as I come to a stop and the engine is choking on fuel vapor and sets the P0172? But that doesn't explain the persistently negative LTFT. Disconnecting the purge valve doesn't seem to make any difference.   I suppose that leaves another dang issue with the fuel injector. A leaking fuel pressure regulator, a new leak in the spider, or a leaking fuel injector/poppet valve I didn't see, or a small crack in one of the spider legs.   The vacuum line leading to the fuel pressure regulator doesn't have raw fuel in it. It doesn't even smell like fuel when it's pulled off, not until you suck air through it, then you can tell it leads to a fuel component. I'd consider that normal? Nothing is signaling this is a FPR issue from the outside, at least.   The oil smells like fuel but it's not building volume. I've noticed most oil in most engines smells like fuel to some degree so it's hard to say if the smell is an issue or not. Or if the engine just still smells like fuel because the crankcase was full of it a few hundred miles ago. But it's been changed twice since that original issue of the leaking fuel line dumping fuel into the intake.   Patience is running very thin. Every win seems to be accompanied by two steps backwards, or another issue that leads to removing at least the top half of the intake manifold. Enough! LOL
    • First off you mentioned "Toyo Says" and then gave the pressures 45/50, was this some person at the tire shop that pulled those numbers out of his head ?   Now of course I can't know your exact axle weights front and rear, however I have much the same pickup as yourself other than not knowing your starting weight as per the pounds the truck rolled out of the factory at due to the options yours did or didn't come with or what you have added beyond the extra tire weight. The correct way to know 100% where a person is at is by weighing each axle with the typical weight the vehicle is driven with and that means taking into account passengers and making sure you figure in a full tank of fuel and a little grace for whatever you may put in the bed "groceries" !    I am looking at and not that it really matters as all the tire companies use the same charts anyway, but I am looking at the comprehensive Toyo tire chart in the section that your tire falls under and I know it sounds confusing but your tire is not an LT metric tire like your factory tire but instead because its a standard inch measured tire its under a different category called an LT floatation series tire. That makes a difference as LT metric tires they don't want to see run below 35 psi at highway speed where as with the LT floatation series it can be run down to 25 psi on the highway as long as the weight on the said size of tire is agreeable with or less than that minimum 25 psi. It blows many people away that how is this physically possible, an empty truck for one thing and larger tires with the same size wheel diameter have a lot more air volume so they can carry the same weight as the smaller tire with less air pressure.    So my truck, I have the stock 275/65R20 wheels and tires and I have a bit of weight in the box with a bak flip cover and a rubber bed mat and some tools and spare gas. The front of my gas truck weighs a bit more than some trucks of the similar spec due to double batteries and alternators. However with full fuel and just me in the truck I am weighted such that I can run 40 front and 35 rear and so that is what I have done since day one.    If I base your truck at or slightly below the weight of my truck, in theory with your tires going by the tire chart you might be right around a minimum of 30 pounds front and 25 pounds rear. Of course that would hit pretty much minimum cold inflation pressure one could run with that tire size and a near empty truck. If you have access to an accurate weigh scale to do individual front and rear axle weights I would suggest you do that and make sure your topped up with fuel and whatever else in the truck before you weigh it and then you will have a great starting point to work off of and figure out what your bare minimum pressures are you can safely run. If you do much in the way of hot weather high speed driving, bumping up a bit for a safety margin is never a bad idea but just depends on what type of driving you do. I will include the Toyo chart and the floatation series sizes start on page 31. Without a doubt at these pressures I am speculating at minimum wise for your truck, it would most certainly ride very different then it did when you were using 55 lb front and rear.     https://www.toyotires.com/media/pxcjubjs/application_of_load_inflation_tables_20200723.pdf
    • Take an automotive stethoscope to the vacuum pump. Iirc those tick as well. 
    • This landing is worse than most. Patchy blacktop with washouts, soft gravel/sand at bottom that washes out with every heavy rain. I tell everyone to put it in 4WD. A lot of them think they can pull out their trailer in 2WD. They end up digging a hole and then putting it in 4WD.  The lake is a pristine lake and has a lot of money on it. There are several wake boats and lot of large tritoons. The people with the money don't want it improved because they don't want more traffic.    Boat Landing 1.jfif Boat Landing 2.jfif Boat Landing 3.jfif
    • How wide are your rims?   Toyo specs 8.5-10.0-11.0 inches. My thought would be rim might be pulling the tire inwards creating a center that is more pronounced.    I also noticed that the spec sheet says max 65psi. So you could be right lowering the pressure to ~40 psi. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...