SO..... Anyone install a lift kit yet? Pictures Please

[MTB10]

HELP!!

 

Just had the 4 inch fabtech installed for the At4 (Overall 6 inch). Put hostile 22x10 -25 with a 3/8 spacer. Looks great but I have a major rub. What are my options. pics below. 

 

 

[MTB10]

[MTB10]

[FirstAscent]

So it’s rubbing on the rear portion of the wheel well correct?

[z1boss]

Have u tried running it without the spacer?  The spacer may be pushing it too far out.

[FirstAscent]

Have u tried running it without the spacer?  The spacer may be pushing it too far out.

I agree with this. I have the same size wheels without the spacer but slightly wider than average tires and they just barely fit, I still had to do some minor but unnoticeable trimming. I know if I added a spacer I’d have issues.

[DanHc]

18 minutes ago, MTB10 said:

I’m no expert but my setup has a more aggressive offset and I barely rub at all at a full left turn only.

[z1boss]

27 minutes ago, MTB10 said:

HELP!!

 

Just had the 4 inch fabtech installed for the At4 (Overall 6 inch). Put hostile 22x10 -25 with a 3/8 spacer. Looks great but I have a major rub. What are my options. pics below. 

 

 

 

Also, what size tire are you running.  The AT4 has a smaller wheel weel opening than the Trail Boss so you cannot run as big of tires.

[BillyDee]

Yikes, looks like it already chewed up that corner quiet a bit. Looks like the tires are too big for that lift, or the wheels need more offset. Assume you took it to an off road shop... what did they suggest?


Sent from my iPhone using Tapatalk

[BillyDee]

As an example, I installed a 6” BDS lift on my RST and used the wheel offset recommended by BDS. I have lots of room with 35x12.5x20 nitto grapplers




Sent from my iPhone using Tapatalk

[MTB10]

34 minutes ago, FirstAscent said:

So it’s rubbing on the rear portion of the wheel well correct?

Yes rear wheel well .

[MTB10]

12 minutes ago, z1boss said:

 

Also, what size tire are you running.  The AT4 has a smaller wheel weel opening than the Trail Boss so you cannot run as big of tires.

Wont clear without spacer

 

[z1boss]

1 minute ago, MTB10 said:

Wont clear without spacer

 

Ok but what size tire?

[MTB10]

Just now, z1boss said:

Ok but what size tire?

tire is a 35x12.5r22 toyo rt 

 

[z1boss]

12 minutes ago, MTB10 said:

tire is a 35x12.5r22 toyo rt 

 

You need different rims/tires or some trimming.  There are 4 sizes listed on the Fabtech site for this lift.  Although it's not marked, the Trailboss is the one that fits the 35x12.5, the 295 width tire is for the AT4.  The wheel wells are smaller as I mentioned earlier.  The Fabtech kit also has a 5" backspacing which your 22x10 doesnt have.  The Rough Country kit accepts your rims offset but not this kit so in reality the best option for those looking to lift the Trailboss/AT4 is the Rough Country kit not the Fabtech one.

 

 

Fabtech:

 

 

 

Rough Country:

 

Edited April 25, 2019 by z1boss