Jump to content

Looking for Pictures of Before and After 2020 2” Level

alvarezz09
 Share

Recommended Posts

alvarezz09 Enthusiast

alvarezz09

Posted
Posted (edited)

Iv been searching the Internet and have found multiple videos of how to install the 2 inch leveling kit but no one seems to do a comparison photo of before and after. I have a 2020 GMC sierra elevation blacked out with the stock rims and tires. Just trying to see if anyone has some pictures of before and after and which route is better for the leveling kit. 

 

53D2FD11-B909-4CEA-8F28-922792D57BD2.thumb.jpeg.93a5058c3f31a75087dba1c9315d6414.jpeg

Edited by alvarezz09
picture
Dunn Senior Enthusiast

Dunn

Posted
Posted

3 fr/ 2 rr

 

AT4 Lift, with springs...can make it level if I want but I haul weight so want the 1" rake

20210504_151813.jpg

alvarezz09 Enthusiast

alvarezz09

Posted
  • Author
Posted
44 minutes ago, Dunn said:

3 fr/ 2 rr

 

AT4 Lift, with springs...can make it level if I want but I haul weight so want the 1" rake

20210504_151813.jpg

Thank you! i really like your setup what springs did you go with and what brand of lift?

Gangly Senior Enthusiast

Gangly

Posted
Posted

Eibach 2" Lift (Springs and shocks up from with shocks and blocks in rear)

 

These shots were before the wheel and tire change.

 

Eibach Lift.jpg

Z71 With Camper Cropped.jpg

alvarezz09 Enthusiast

alvarezz09

Posted
  • Author
Posted
26 minutes ago, Gangly said:

Eibach 2" Lift (Springs and shocks up from with shocks and blocks in rear)

 

These shots were before the wheel and tire change.

 

Eibach Lift.jpg

Z71 With Camper Cropped.jpgPerfect! Thank you for the side profile picture that’s what I want to do with mine.

Dunn Senior Enthusiast

Dunn

Posted
Posted (edited)
22 hours ago, alvarezz09 said:

Thank you! i really like your setup what springs did you go with and what brand of lift?

Bilstein 5100 with eibach springs in front....2" block in rear  ...still on stock wheels and tires, put bigger tires on when these wear out

 

this is really common setup.......bilstein, eibach, fox, and ton of others sell adjustable struts

Edited by Dunn
BowtieBill Enthusiast

BowtieBill

Posted
Posted

First two are without level. Third one is with Bilstein 6112's in front, 1" block and 5160's in rear. Last one is with new wheels/tires.

1630320580_2020ChevySilveradoLTZside.thumb.jpg.a9f60492de6f80a46b2ecb6190764be6.jpg

2020 Silverado 4_21 side.jpg

2020 Silverado leveled.jpg

2020 Silverado_New Wheels_2mp.jpg

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • KARNUT
      2027 GMC Sierra: Official Discussion

      By KARNUT · Posted

      It really is comical when people don’t agree or see the reason some people prefer the older vehicles. They become condescending. All the while they may be busting their knuckles on old vehicles. I have found memories of swapping out engines in my old GM cars in a weekend without much hassle. Unlike today. One wrong move a computer will shut you down. Even on something as easy as a brake job. There’s a pretty comical YouTuber called the car wizard. A garage owner who puts it all in perspective. Another Vicegrip garage that’s shows just how tough the old stuff is. 
    • Jsdirt
      2027 GMC Sierra: Official Discussion

      By Jsdirt · Posted

      I was around and remember that era very well, so I'm calling b/s on that statement. If they were that bad no police department or taxi company would've bought a single one ... but they were used in both services (and fire) for DECADES. They were bulletproof and proven. Even the early 21st century ones weren't too bad! The early models were legendary.   Mine is proof, but people like atlas are blinded by agenda and refuse to believe facts right before their very eyes.   Even decades after they were built, a new generation started driving them, posting all their builds and shenanigans on Grandmarq.net and Crownvic.net. The failures would show up then, since they all were deep past 100k-150k miles by that point, and younger drivers tend to be a little aggressive, especially with vehicles than can lay a one-tire fire for as long as you hold your foot in it. They've more than proven themselves over the decades.   The only thing that'll really take them out is road salt. The bodies and sheet metal were garbage. A victim of the cheapout FoMoCo and GM have been partaking in before then, and since.   Today it's the stuff that counts - the undercarriage that rots away first!    GMs Caprice was no slouch either. Reliable as a stone ax - the opposite of what they build now.    
    • Jsdirt
      2027 GMC Sierra: Official Discussion

      By Jsdirt · Posted

      Let me know how your vehicles do in 10 years. You don't know ******, kid. 😂    There's a reason that Panther platform was used as police, fire, and taxi service for DECADES ... long before you were born, apparently.
    • davester
      Disconnecting Battery

      By davester · Posted

      If your connector also has a big lever to get the connector on and off, you don't want to force the lever either way, as it becomes a bigger problem if you bust the lever or the mechanism it works.
    • davester
      Disconnecting Battery

      By davester · Posted

      It's just useful to disconnect the battery to prevent odd shorting out when unplugging/plugging stuff together.  I also  touch the two cable ends together (after disonnecting) to drain the small amount of stored battery energy in various modules.   I believe the main system where you need to be more concerned with, so you need to do the above and then wait some time, iss when you are working on the air bag system, to prevent inadvertent firing of the air bags.   The in-cab switches are just that, plain switches, it's generally not a problem to swap them in/out.  For my '12, I'll get an error message on the dash if I power up the truck w them unplugged, but that's it (power up= turn the ignition on).   The ITBC located above the spare tire is a computer that manages the trailer brake system.  That is probably more important to have the battery disconnected.  It does have to be programmed to the truck, either before or after it's installed, for it to work.  For my '12, I had a very hard time reinstalling the main connector to it (IDK if yours is the same or not), it turned out the silicon seal was jamming up, preventing it from going on all the way.  I finally got it fully installed by lubing the seal with a bit of dielectric grease, then it slid on and latched in place easily.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...