Truck started to make a squeaking noise this weekend, took it to the dealership on Monday. Dealership called Tuesday and said that they could not find anything wrong with the truck and that this sound is normal. Take a look at this video so that you can hear and understand what I am talking about. https://youtu.be/aERzjGAX-aU
Does this sound normal to you guys? I also put water on the belt and the noise was persistent so it does not appear to be the belt. Any help would be greatly appreciated!
Hey all, SO let me start by mentioning I changed out my stock lower ball joints to Moog lower ball joints on November 5th, 2016. This being said, I removed the stock LBJ after 40k miles (20k on level w/ stock tires, 20k on 6" RCX knuckle and spacer lift w/ 35x12.5 tires and 20x9 rims @ 0 offset), and it looks like I am needing to replace them AGAIN! Barely even 10k miles later I am seeing the same irregular wear pattern as when I had the stock ball joints. I greased them when new and at oil change (every 5k mark). I got the vehicle aligned the following day after I installed the new LBJ btw, and I also changed the UCA to cognito arms at the same time.
What I am curious of is if the issue is lying in the stock rancho shocks and the spacer lift maybe being too rough on the LBJ on the truck, this being said, does anyone else with more knowledge/experience in this area have any advice or other possible causes? I have searched the internet and haven't found anything really definitive so Im at a loss. I am at 50k right now and will have the truck at the shop within the week to get the alignment checked as well as other routine maintenance performed.
I am just at a total loss and don't want to run through these new tires nearly as fast as I went through my old ones (barely even 25k miles before the edges were at 10% tread remaining at best)
The rear tires are wearing beautifully but the fronts are wearing from the outside, in. The outer scalloped edges are all even and smoothed out, whereas the interior side of the tire still has extremely defined edges that look practically brand new
I'll get photos and attach for reference.
Thanks in advance for any help.
I am working on a 2002 Chevy 2500 HD. The ignition key is sticking when you turn it, and will remain in the cranking position sometimes. I swapped out the ignition cylinder and key, everything is all good there. I also know that the cylinder and key is not the issue, because when the cylinder is removed, if you take a large flat head screwdriver and turn the "recepticle" (female end) of the ignition cylinder, it still sticks. I tried lowering the igntion switch and even without the switch in place, it still sticks. Any feedback will be greatly appreciated.
Recently Browsing 0 members
No registered users viewing this page.
Most OnlineNewest Member
Who's Online 101 Members, 0 Anonymous, 381 Guests (See full list)
- Foley Fats
- Hawaii 5-0
- Frank Rizzo
- 300 Blackout
- Troy Harner
- Sean Hartley
- 2017 ltz