Jump to content

Recommended Posts

Posted

Well, I say I like the Ram..... but if it came right down to it, I don't know if I could make myself do it!!!

 

I've never owned anything but GM. I'm classic GM-Loyal. :thumbs:

 

I had a Dodge Dakota when I was 19 (10 years ago) but the Silverado has always been my dream truck. Bought my first one in 2007 which was a GMT900 series and it was ok....I had transmission problems at 80k miles and then the oil consumption issue developed around 95k miles. Faced with the prospect of replacing the engine, I went and test drove a Tacoma, an F150, and the 2014 Silverado. I just couldn't do Ford...I felt dirty sitting in the dealership. But really at the end of the day I was not impressed with the F150. I decided I didn't want to downsize to a Tacoma and I didn't like the Tundra at the time which was the previous body style. So I took a chance on Chevy again thinking they've turned a corner and there's no way I'd get another truck with the same problems my 2007 had. So far the worst thing with the 2014 for me has been the rust issue on the frame. The vibration comes and goes and I'm thinking it's tires but I'm not 100% sure....it's not bad enough to lose sleep over and as I posted above, it hasn't vibrated much at all this summer.

 

But I'm like you man I'm classic GM-loyal. My dad has owned a Silverado or a Suburban since 1995 so I've grown up around these trucks and their changes over the years. I want them to succeed and be better after the bailout. Silverados/Sierras are still the best looking trucks on the road in my opinion.

  • Like 1
Posted

 

I just couldn't do Ford...I felt dirty sitting in the dealership.

I literally just spewed my coffee. :crackup:

  • Like 1
Posted

I think in your case and mine it's a tire issue. The seat shaking could be rear end related. But if that's the case then every truck I've owned for the last 20 plus years has had a rear end issue that didn't cause a performance problem.

I don't feel it's my responsibility to replace the tires on a new vehicle if they're not of good quality. The last road force balance number reported was 18. I think that's too high but the specs show the tire can be up to 24 before they are to be replaced.

 

Levi, the specs on the new trucks for RF since they are so sensitive is 19. The GMT900 Road Force spec was 24 but the new ones are lower. Not sure if your dealership received correct literature but you are basically at the high end of the tolerance for the new truck. Anything under 15 should be good. I have one at 17 and am still having issues. The rest are under 11.

Posted (edited)

I'm curious if any/many of the 3500HD's have this problem also. I just saw one and wow was it beautiful. He said it was a 2015 and like my 2014CC he had no issues with it. Black like my 1500 but 3500HD with the diesel and a lift kit to fit the larger wheels. Man what a beauty. It's just that I really don't have the use for a 3500HD very often and with the mileage being so good on my 1500 I'd have a hard time justifying it.

Edited by Mad Max
Posted

What about a shake in the wheel that was there a lot in the spring through June, and then has been mostly non existent up through now except the occasional cooler morning (60-70 degrees) where it will shake for about a mile down the interstate and then stop. Tires? I'm still thinking tires..........

Mine did this with the stock Continental tires; it stopped when I changed them to Michelins. Now smooth...

Posted

Those who are currently following this thread, if you still have vibration problems, please post where your truck was assembled and if you have a short or long bed.

 

I have a short bed crew cab assembled in Mexico.

 

The last time I spoke with a representative at GM they mentioned that they believe the problem is worse in the long bed trucks because of the two piece drive shaft.

 

Thank you for your participation.

 

 

MIne is a long bed. i dont know where it is made because it is still sitting at the dealership waiting to be fixed. They gave me a short bed to drive as a loaner, it vibrates. I have driven 7 2014 's so far, they have all vibrated, they were all short beds except mine.

Posted

To be more specific. my truck is a crew cab standard bed. The loaner is a double cab short bed. i have driven crew cab short bed and even a crew cab short bed high country. still vibrations and this is the low speed vibrations between 25-50mph. havent even tried 65mph+

Posted

Mine did this with the stock Continental tires; it stopped when I changed them to Michelins. Now smooth...

 

Yeah I have goodyear wrangler SR-A's. I'm cheap though and driving them until they wear down. Then I'm going with either Michelins or BF Goodrich. You get what you pay for with tires I've learned.

Posted

Yeah I have goodyear wrangler SR-A's. I'm cheap though and driving them until they wear down. Then I'm going with either Michelins or BF Goodrich. You get what you pay for with tires I've learned.

Certainly has been my experience.

Posted

The point is that some members in this forum ridiculed those who complained about these problems and asserted that only a very small number of trucks have this issue (without having any data to show of course). They encouraged others to buy these trucks without any hesitation, as there was supposedly very small chance of having a vibration problem (or any other problem). Looks like the probablity is quite high.

So your statement was pointless. If it was suppose to be sarcasm towards some of the other members it didn't work.

Posted (edited)

I purchased michelins because I hate the goodyear SRA's and didn't want to suffer through them. With the Goodyears the truck would shake a little and had an awful bounce after it sat awhile.

With the Michelins sometimes I still get a shake for about the first 1/4 to 1/2 mile after it sits for awhile then it's gone.

 

 

I do still get the vibration sensation in my accelerator and floorboards though but I have learned to live with it, I've got worse problems to deal with.

Edited by 14LTZZ71
  • Like 1
Posted (edited)

Well I am now joining in on this excitement.... I recently purchased my 2014 GMC Sierra Z71 4x4 Crew Cab 1500 with the short box. I noticed a vibration that is noticed around 65+MPH, but felt most at 75-85MPH. I took it in for service for the recent recall ( 4x4 slipping from neutral or something of that sort ) and to have them see about the vibration. They called me ( Hiley GMC in Fort Worth, TX ) today to say the service was completed. I called back to see what the vibration was and to see what their fix ( after reading much of this post ) was. I finally was in contact with the service guy and they told me that GM was aware of the issue on all 4x4 truck and a fix is not yet available. I asked when he thought a fix would be rolled out and I was told most likely in the next 2-3 months... Geez.... My truck just rolled 1000 miles this weekend also.

Edited by CFlatt
  • Like 1
Posted

Good day all, my vibration still exists after 5 visits and the dealership has been instructed to not work on it anymore. I will admit mine isn't as bad as some in here and I only feel in the rear so a little easier to handle. GM Tech Support says its not that bad and to do nothing else, complete bull and taking it to another dealership.

 

The phone number for the GM Customer Support Executive department is 1-855-880-1500, please be advised they don't return phone calls either. I honestly think we need to start putting in BBB complaints and contacting the NHTSA about a possible safety issue since GM doesn't know whats causing it. Every BBB comnplaint has to be answered. This is truly getting old because every time they have the truck they are putting over 50 miles on it test driving it and not paying for the gas or filling up the truck.

Posted (edited)

Good day all, my vibration still exists after 5 visits and the dealership has been instructed to not work on it anymore. I will admit mine isn't as bad as some in here and I only feel in the rear so a little easier to handle. GM Tech Support says its not that bad and to do nothing else, complete bull and taking it to another dealership.

 

The phone number for the GM Customer Support Executive department is 1-855-880-1500, please be advised they don't return phone calls either. I honestly think we need to start putting in BBB complaints and contacting the NHTSA about a possible safety issue since GM doesn't know whats causing it. Every BBB comnplaint has to be answered. This is truly getting old because every time they have the truck they are putting over 50 miles on it test driving it and not paying for the gas or filling up the truck.

I think some people have more success contacting GM customer assurance online. They even have live chat.

As for the Executives Department, you know they don't want to hear our complaints because then they will have to deal with it. It's better to put on the blinders and ignore it. At least long enough to get their yearly bonus.

If GM engineers can't figure some of this stuff out what good are they, I think it's time for new recruits, with ideas that actually work on paper and on the vehicle.

Edited by 14LTZZ71
Posted

Giving I've only taken my truck in once to get serviced for said issue, would I benefit from opening a case with the BB over the vibration issue since they have told me no solution is available right now and I will be contacted once a solution is determined?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Question @diyer2 on this line if you please. Are you saying the shudder is the system turning on and off at the frequency of the shudder? Guess I'm asking if you are saying you have seen it do this with the bi-direction scan tool in graph mode? If so have you been able to discern the 'trigger'. Something is telling to cycle rapidly.    My truck just started doing this recently. 197K on the clock. My response has been M5 anything under 55 mph. I treat it like a lugging stick shift. Gear down and let it spin a bit. Engauge M5, then tow mode and then M6 lets the trans stay in 5th but the AFM is active. Smooth like Skippy.    My thought was that as a machine ages the friction gets lower and as the system is load based, the lower friction would allow it to turn on at ever lower rpm until it reaches the lugging point. And yes I am ignorant of any minimum rpm requirement for the system. If you know that would be useful information.    As you know I run a Scan-Gauge II which allows me to watch the On/Off of the signal to the VLOM. While in the shudder mode I'm not seeing is cycle at that frequency or at all for that matter outside the triggers @newdude posted a few years back. Now is it possible that the refresh rate isn't fast enough to catch it? Maybe. It is why I asked my first question about graphing and trigging parameter.     As we have observed from members here the failure point is all over the map miles wise as you note yourself in your opening post. That by itself begs a few questions like fellows that comment on these lifters failing even after the system has been disabled. Long after. 😬   https://www.enginelabs.com/news/tech-tips-replacing-ls-active-fuel-management-lifters-with-melling/   The Gen5 lifters operate the same as the LS versions. In fact they are the same lifter.    https://www.enginelabs.com/tech-stories/sorting-out-gen-v-lt-lifter-failure-with-a-simple-valvetrain-fix/        
    • UPDATE 2: Steering wheel control backlights and control of the cluster can supposedly be achieved by adding a wire to pin 20 of the cluster and tapping it to pin 2 of the main clock spring harness. I'm going to give it a shot - will update  
    • GM Global A pickups 2019-2022 can do OTA programming for the radio.  GM VIP (GM Global B) can do OTAs for almost every module on board.  So a 2022.5 and newer pickup can do OTAs for recalls like the 2.7 fuel flow recall.  EVs get OTAs that improve one pedal driving, radio issues, HVAC issues, updated battery management software, etc.     So age of the vehicle/what GM electrical platform its on will alter what amount of updates can be pushed on OTAs.  
    • Thank You.   So far my new ride is making me look like a genius for going with the 3.0L, as my first fuel refill occurred over three weeks from when I took delivery.  This engine combination is very amazing.  So far no issues and had not done a regen yet.
    • I am curious as to how much fluid you put back in the transmission ( assuming you had replaced the filter to compare to my findings ) and then went through the process of warming up the trans before pulling the check plug to drain out the excess and if you measured how much came back out.    I just found it surprising that some claimed a certain amount less fluid being put in and then draining some back out. The attitude of the truck as per if the surface is level and how the trucks stance is would make quite a difference since the check plug is right at the front of the transmission. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...