Jump to content

Recommended Posts

Posted

Anyone else with a new 2014 Sierra having an issue with the frame rusting and paint/wax flaking off? I have 3000 kms and it looks horrible. I also own a 2011 Canyon service truck with 105kms and the frame looks like new. So irriating as my Sierra is a beautiful truck aside

Posted

Ya talk about frustrating, I just cleaned the snow off mine this morning and I noticed there's all surface rust spots along the front bumper. Not very pleased at all, the trucks only 6 months old.

 

First complaint I've had about the truck.

 

 

Sent from my iPhone using Tapatalk

Posted

Ya I'm doubting that, there all on the top line of the bumper all the way across. There not just random spots on the front.

 

 

Sent from my iPhone using Tapatalk

Posted

I have surface rust on my frame also. Alot of salt on the roads this winter in Ohio. I always spray underneath as often as I can .

Posted

There is a TSB out on this, GM had some problems with the wax coating on a small run of trucks. Take it into the dealer as the TSB gives direction on how they are to repair it.

Posted

Any idea on what the tsb fix is? I know on earliar silverado models I have seen frame rust on trucks that are unsold sitting in the dealers lots.

Posted

I remember that when I had my truck on a lift, frame coating in contact areas with lift rubber pads came off and stuck to the pads. I just recoated the bare spots with rubberized undercoating. If the spots are small and there is rust present, you can just brush it with wire brush and spray on some undercoating.

Posted

I don't have a problem with the frame, but the rear axle has light surface rust on the shock mounts and diff cover. I live in S Fla. And haven't seen salt

Posted

I don't have a problem with the frame, but the rear axle has light surface rust on the shock mounts and diff cover. I live in S Fla. And haven't seen salt

This is very common on these trucks. Mine truck has it too. I went as far as ordering a new differential cover and to my surprise, it was bare metal, not even primed, and had rust spots on it already! Plus it had an extra fill plug and no drain plug. I returned it becuase i would have had to sand and repaitn the new cover, so I just might repaint my old one.

 

The best solution for the differential cover rust is to wire brush the cover with drill powered wire brush on the truck, then prime with black primer and give it several coats of black enamel from a spray can.

Posted

This is very common on these trucks. Mine truck has it too. I went as far as ordering a new differential cover and to my surprise, it was bare metal, not even primed, and had rust spots on it already! Plus it had an extra fill plug and no drain plug. I returned it becuase i would have had to sand and repaitn the new cover, so I just might repaint my old one.

 

The best solution for the differential cover rust is to wire brush the cover with drill powered wire brush on the truck, then prime with black primer and give it several coats of black enamel from a spray can.

I was looking for a polished stainless steel one for mine. Can't find it online anywhere.

Posted (edited)

Count me in for the rust! I've been playing with the air pressure in my tires to see if it makes a difference in the ride and vibration that I feel, and I was letting air out of the left rear tire and noticed my undercoating cracking and peeling with rust under it. Look under the truck and found more under the area of the rear door. I have spots of rust hear and there all over the frame and that's probably somewhat normal, more of a bleed through and my deaIer had my truck up on a hoist at least 3 times and where the pads touch the frame the wax came off and it's rusting. That suff Is going to happen to all the trucks but it should be peeling and cracking off in non wear areas. Checked the right side and so far it's ok but I bet it's just a matter of time.

 

I'll try to get some pics up.

Edited by Silver Spaceship
Posted

i noticed on my frame this weekend to that the ''wax'' paint can be scraped off with my finger..why dont they paint these frames with paint! im worried the pressure washer is gonna chew that stuff right off..i want my old 04 painted frame back..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • The “engine hours” display is there because the truck detects the key presence as you were thinking.   My first step would be to call a dealer service person and ask if this a known issue and how they deal with it. If you don’t get meaningful advice there, i would try a couple of DIY things before bringing it in for troubleshooting/repair.   It sounds like a mechanical key detection switch is stuck, but I have not actually seen what the internals look like. Maybe spray some Caig Deoxit (electrical contact cleaner) in the key hole and work the key in and out in case it’s an electrical contact cleanliness issue.  If that doesn’t work, next apply whatever lubricant GM recommends and work the key in and out a few times.    Good luck with it. 
    • Carbon on valves would be the least of my worries on a light duty, 1500-series pickup with 357k provided the engine still ran halfway decently. Everything else is likely toast, on its way out, or has already been mauled to death by cheap mechanics and backyard fixes. Those kinds of trucks nickel and dime a guy to death.   I wouldn't think having the top end cleaned once or twice would be a big deal on a 5.3 but maybe it is?
    • I wonder how much carbon is on all those high mileage valves?
    • When I had a Bumper subscription for a few days when I needed to run title histories on cars I was looking at, I decided to look up a few of my old/past vehicles.   My 2015 Silverado was still actively registered and it last sold in 2024 with 160k on the clock. No idea if that's on the original engine but someone's keeping it on the road or the original AFM stuff is still going.   It used 0w20. I remember feeding it Mobil 0w20 AFE for the first 30k of its life on <5k OCI's.     Edit: Just did a nationwide search on Autotrader for 2015-2025 Silverados with 5.3's and sorted by highest mileage first.   357k 352k 292k 291k 290k 277k 271k 268k 266k 259k 256k   High mileage on a modern 5.3 doesn't seem all that uncommon, but that's just searching mostly dealer ads on Autotrader. FB Marketplace has all kinds of high mileage 5.3's going back to 2007    
    • I can't say I have ever heard of someone getting that type of mileage out of a set of tires even though they rotated on a regular basis but without a doubt if the front end gets wear and those tires are no longer able to track straight it scrubs them off, and driving style and road surface make a huge difference as well.    However that is not what prompted me to comment as it was the new tire theme of sitting in storage waiting to be used scenario. I am sure some tires can last for quite a while in storage if its not too warm and out of the sunlight but unfortunately some tires the way they their rubber compound is formulated they can age and dry out even in a reasonably decent storage location. My brother ran into this maybe three years ago when he was looking at the tires that were on his dually truck and a combination of wear on the rear ones and noticing that the front tires had some cracks around the sidewall of the tire not far from the bead but he had replaced only the front ones not long ago with 2 of the remaining 6 he had left from the initial two sets of takeoffs he had all bought at the same time .... 10 years ago ! ( the years fly by, a truck that only gets used a bit to haul a camper during the summer and sits in a shed for a large part of the year ). That second set of 6 tires, two he had put on the front prior like I said and they had very little wear but those cracks were now present. So we go into the shed where the other 4 tires had been stored all this time and every one of them had the same cracks in the sidewalls and so in the end it amounted to throwing away 6 brand new but 10 year old takeoff tires into the dump that he got a deal on at a tire shop because they aged out. They were a Ford factory equipment BFG tire and those tires did not age well compared to some tires I've seen far older then that and did not show that type of aging. True, they always say up here anyway that 7 years is sort of a limit for age by rights, we don't have the intense prolonged heat that many of you have down in the states that just cook tires and depends on where the vehicle sits when not in use. GB, another words maybe had you bought a set of tires to store it would have been fine as long as you used them up fast enough but there are no guarantees when it comes to rubber, tires or of that other type stored in some guys wallets 😆
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...