Jump to content

Recommended Posts

Posted

 

On my 2007, I ordered Bilstien 4600's all around but they sent me the ones for the 2007 Classic silverado by accident. The shocks up front were wrong but the ones in the rear still fit. My mechanic who installed them said they would still work in the back but I'm anal about these things and called Bilstein to ask them if the rear shocks would work or if I needed the correct part number. The guy on the phone claimed they were valved differently on the new body style truck versus the classic. I guess that kind of makes sense with regards to vehicle weight and suspension characteristics. I ended up returning the wrong shocks and waited for the correct shocks for my truck. Long story short with these 2014's being different than the 2013's, I personally want to wait until Bilstein comes out with a specific shock and part number for these trucks.

 

In that thread, a few guys actually called/talked to Bilstein. I doubt the valving would be off very much even if they did release a 2014+ specific rear shock. A rear shock on a leaf sprung rear end...is pretty standard all around.

Posted

Dealer installed a new shock. Cant really tell if there is a difference yet. No noises though.

Posted

Dealer installed a new shock. Cant really tell if there is a difference yet. No noises though.

 

My dad's 2003 Suburban makes the same noise in the back. My dad claims it always made that noise which tells me it's the leaf springs if that's the case. I think his started after my cousin installed Rancho shocks on it because I don't remember ever hearing the noise the first few years he had it. Either way I think it's a suspension issue that's not bad or dangerous, just annoying.

Posted

 

My dad's 2003 Suburban makes the same noise in the back. My dad claims it always made that noise which tells me it's the leaf springs if that's the case. I think his started after my cousin installed Rancho shocks on it because I don't remember ever hearing the noise the first few years he had it. Either way I think it's a suspension issue that's not bad or dangerous, just annoying.

 

Well the shock was toast anyways. it was leaking oil. But my service writer says that GM allows for a little bit of oil to leak from those shocks...says its normal...lmao

Posted

 

Well the shock was toast anyways. it was leaking oil. But my service writer says that GM allows for a little bit of oil to leak from those shocks...says its normal...lmao

 

haha yeah Bilstiens don't leak. In fact a leaking shock is a sign of shock failure. I'm so sick of the "this is normal" line when GM or a dealer doesn't want to face a problem.

Posted

I would like to add to this thread.

 

I have been noticing a clunk / thunk noise coming from the rear of the truck when traversing uneven terrain and bumps, mainly on the dirt road leading in to my neighborhood. I thought it was a shock as many in this thread have concluded. So, this weekend, I had someone shake my truck side to side using the rear hand hold stake pocket while I was under the truck. I found that it is deep tone metal to metal thunk on the backside of the passenger rear wheel. I immediately called the dealership and took my truck in. When I got there, the service writer went to get the tech who diagnosed this exact noise just 2 weeks ago as a heat shield. When I shook the truck for the tech and the sound immediately repeated as it it did in my driveway, he did not hesitate to tell me that it was normal for any solid axle vehicle to have slack and that noise is the slack being taken up. My wife and I both questioned him as I have not ever heard this type of noise (plus you can actually feel it when you put your hand on the center cap) and he swore that it was normal. I've not shaken any trucks on thier lot, but I will be soon.

 

Has anyone else heard of this? Am I being paranoid? Is this normal?

  • 4 weeks later...
Posted

I have had my 2014 Silverado now for 8 months & 13,000 miles, it still makes the creaking and popping noises on damp or rainy days. I had the dealership look at the truck three times now and they cannot determine the problem because they cannot duplicate the noise. I am at a loss on what it is , if I was to guess I would say it's the Rancho shocks. I am temtpted to replace the shocks but struggle with paying for shocks on a new truck. Has anybody figured out the problem completely? What are the thoughts of damp wet days effecting the truck and bringing on the noise?

  • 1 month later...
Posted (edited)

It's most likely the leaf springs. Had mine replaced... all good.

See my post under shakes and vibrations....dated 8-16-14....Replaced my rear springs...also cured my problem. (page 176)

Edited by gjk1932
  • 2 months later...
Posted (edited)

I have a 2014 GMC Sierra SLT 4x4 with 1400 miles on it. I just bought in September 2014, and my truck is producing the same sounds as the original poster of this thread. Just started around 1400 miles and I have only noticed in morning after sitting all night or also when wet/raining. I hear the popping (kinda like knuckles popping) when taking off from a dead stop but once I get speed up, i can't hear anymore. Then it does it again a few more times when I stop and start and then it just goes away until the next cold morning or wet outside. Sounds like its coming from back passenger side. Anybody know if anything came from this issue? It seems like many users have experienced this issue and most replys say shocks or leaf springs. Any more updates? thanks.

Edited by 06sierraman
Posted (edited)

My 2014 ext cab z71 has had the same problem for about 6 months. I've taken it to the dealer 4 times and had the leaf springs replaced and it still makes the noise everyone is describing. I'm really frustrated at this point. Has anyone found a solution????

Edited by Eaglecougar
Posted

My leafs still creak and pop. Its annoying but oh well. This is considered normal by my service writer.......

Posted

I have my truck at the dealership as I write this. I too have had the noise had both rear shocks replaced and now that the weather has changed im positive it is the rear leaf springs. With that said has anybody had the below done and if so how long did it help or did it help at all?

 

Condition
Some customers may comment about a squeak noise coming from the rear of the vehicle. During normal operation, certain vehicles may exhibit a squeaking noise that may be traced to the rear leaf springs. While this noise is an operating characteristic of leaf springs, the frequency and severity of this noise will be affected by the roads that the vehicle is driven on.

Cause
This condition may be due to debris getting between the leaf springs.

Correction
To correct this condition, lubricate the rear leaf springs using the following procedure.

Important: It has been found that the application of grease to the rear leaf springs does a better job of preventing the noise from reoccurring than replacement of the spring.

Raise the vehicle on a frame lift-type hoist.
Inspect the springs for damage. If none is found, proceed to the next step.
Pressure wash the rear leaf springs to remove as much dirt and grit as possible.
Dry the springs with compressed air.

Apply a liberal amount of grease, P/N 12345996 (in Canada, use P/N 10953501), under the front and rear tip inserts for the #2 and #3 leaves, on top of the tip inserts, and in between the #1 and #2, and #2 and #3 leaves, as indicated below. A screwdriver can be used to gently pry up the tip insert; however, a rag around the screwdriver must be used to prevent damage to the spring. Use a flat-bladed tool, such as a gasket scraper to properly distribute the grease.
Lower the vehicle to the ground and test drive to verify the repair.
Please inform the customer that this will offer relief, it is by no means a lifetime repair. Periodic cleanings and grease re-application may be necessary throughout the life of the vehicle.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • No ETA is available for that engine at the moment in the GM system.   I would start at the dealer.  Try and talk to the parts manager or service manager and see if they can start a CX Connect case and get an ETA from GM on when engines may be available.  If they just check Parts Workbench and say "no eta", they aren't trying hard enough.  They need to do a CX Connect and chat with DPAC to find the ETA.      
    • I would have to read back to get a better picture in my mind of some of the other comments and what they were using for a driving scenario they based the fuel mileage off of. That is why the fuel mileage conversation is extremely difficult to make fair comparisons from. If I was to be living in town and only driving around town, light to light and some longer stretches that doesn't have a light every block, and the usual stop at a grocery store and the bank and so on and so forth, my fuel mileage even during the summer time would be so bad with my truck I don't even want to know how bad it would be !. Then add in winter time and idling to warm it up to clear the windows and driving through snowy streets etc, large heavy trucks with gas engines have NEVER been worth crap for fuel mileage and why some little pot licker of a car with wheelbarrow tires and a 1300 cc four cylinder non turbo engine was the ticket to using a mere fraction of the fuel over a full size pickup.    By the way my truck has the 34" tires as its a HC but not the BFG KO3 tires ( that was an option for my truck but the sales guy couldn't figure out what the tires actually were so that never got on the order until it was too late to change the truck order ). So what fuel mileage your getting actually sounds good for "town driving" and with my truck when I go to town the fuel mileage keeps increasing as I get closer to town because it takes quite a while to get the driveline oils warmed up ( and why it always shows better fuel mileage on the return trip from town because its already warmed up ) but once I am in town that fuel mileage average just keeps dropping the more I mess around town and then has to recover back to something reasonable again by the time I get home for an over all average.    I'd be curious what your sticker says for the factory weight of your truck, mine is close around that 7700 lb due to the options it has. But anyway the long and short is, vehicle weight, higher rolling resistance heavy tires and a hefty driveline and a relatively large gas engine make for crap fuel mileage in stop and go scenarios, all one can do is drive it easy off the line at each stop and as my dad had said over the years, drive like a raw egg is under your foot and that's the best one can do. Years back with a carbed engine and if the carb was getting a bit out of tune etc as would the ignition system, the fuel mileage on pickups with larger engines was just awful compared to what your getting. We pay the fuel price penalty for driving HD trucks over some little vehicle, that is the reality. 
    • We had two Toyota’s with that engine in the mid 80s. We had 50 gallon fuel tanks, a toolbox full of tools, an air compressor and assorted parts for our equipment. We beat those up and down pipeline ROWs until we started buying diesel trucks. Then they became parts runners and first vehicles for our teenagers first cars. Our shop Forman wrecked them both two years apart when we hired him out of high school as an apprentice. Good thing he’s an excellent mechanic. It took awhile before he could be called a good driver.
    • $4.26 85 oct 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...