Jump to content

Recommended Posts

Posted

 

 

Check to see if this is happening when your AFM switches to V4 mode.... I noticed this too and was told it had to do with the engine running on 4 cylinders.

I think they are full of it. AFM transition is smooth and smooth even in 4 cyl mode and doesn't cause a vibration. My 2013 AFM was smooth as well.
Posted (edited)

Yes, I understand that there are tolerances, and you could be close to either end of the spectrum therefore feeling something that you may not feel in another truck but GM and the dealerships have taken this normal, operating as designed, operating within the normal characteristics of vehicle design, can not duplicate crap way to far lately. It's turning into a "get out of jail free" card.

Edited by 15LTZZ71
Posted

I think they are full of it. AFM transition is smooth and smooth even in 4 cyl mode and doesn't cause a vibration. My 2013 AFM was smooth as well.

 

It' not the transition that I notice. It's more like the engine is struggling to push the truck down the road in V4 mode when going 50 mph. I notice mine more at 35mph.

  • Like 1
Posted

 

It' not the transition that I notice. It's more like the engine is struggling to push the truck down the road in V4 mode when going 50 mph. I notice mine more at 35mph.

Yea that's odd... something's not normal with that.

 

It' not the transition that I notice. It's more like the engine is struggling to push the truck down the road in V4 mode when going 50 mph. I notice mine more at 35mph.

Yea that's odd... something's not normal with that.
Posted

After taking mine in for its first oil change (8000 kilometers could not let it go any farther in my mind)talked about the vibrations to service writer.They balanced tires found one that needed rebalancing could not duplicate the v4 shake....the owners son volunteered to go for a ride (my complaint is that when the v4 has no load or slight load on the engine it really shakes) so when driving around side streets it's worse than the highway but still noticeable when not excelerating.So while side streeting it went into shake mod around 1100 rpm.he immediately said that's not right.

 

Bottom line he felt it was something in the exhaust causing this(harmonics my term)said he would send a message to gm but more than likely wait for a recall.

 

Think I'll send my own as well

Jim

  • Like 1
Posted

Hightong, I am getting the same shake in V4 with my 4.3. Low speed kicks into V4, try light acceleration and bam she vibrates, have to goose gas to get it out of V4. Even get it at highway speeds. Keep us updated.

Posted

After taking mine in for its first oil change (8000 kilometers could not let it go any farther in my mind)talked about the vibrations to service writer.They balanced tires found one that needed rebalancing could not duplicate the v4 shake....the owners son volunteered to go for a ride (my complaint is that when the v4 has no load or slight load on the engine it really shakes) so when driving around side streets it's worse than the highway but still noticeable when not excelerating.So while side streeting it went into shake mod around 1100 rpm.he immediately said that's not right.

Bottom line he felt it was something in the exhaust causing this(harmonics my term)said he would send a message to gm but more than likely wait for a recall.

Think I'll send my own as well

Jim

If you put it in M5 does it still happen? M1 - M5 will keep it out of V4 mode.

Posted

15LTZZ71, running in M5 keeps the AFM from engaging? I drive 25 miles one way to work everyday mostly highway. I do not drive highway in M5 so it happens then.

Posted (edited)

15LTZZ71, running in M5 keeps the AFM from engaging? I drive 25 miles one way to work everyday mostly highway. I do not drive highway in M5 so it happens then.

Ok, going into V4 mode and AFM means the same thing. I was asking Jim (Hightong) though.

 

Edit: he said in his post, when driving around side streets its worse then it is on the highway.

 

Edit: Just wondering if he drives it in M5 does it still vibrate?

Edited by 15LTZZ71
Posted

My turn to join this never ending issue. Took my 2014 sierra 1500 cc ltz in for it's 2nd visit today to look at steering wheel vibrations. Problem has been there since new and had rf balancing on tires done at 500 miles, mechanic said it felt fine after. Sorry felt exactly the same, vibration starts at 45 mph and continues to 55mph but only in the steering wheel. Does anyone remember if there was a fix for this type of vibration, sorry not enough time to read through all 212 pages for ideas. Presently at 1900 miles and curious what dealer will try and say this time.

Check my posts re: rear diff. exams and replacement.

 

PMurray

Posted

Thanks PMurray truck is still in shop and they are looking at this. They said they had 1 like mine and replaced the rear end in it and solved the steering wheel vibration.

Posted

Well, tired of my 2014 Chevrolet Viberado LT - went shopping for new trucks just to see how they ride ect ect. Came out of a 2004 Titan SE off-road, and really like the 2014 Titan Pro-4X - took it for a test ride and rides nice - so now the money issue comes up - willing to take a bit of a loss to get out of this over engineered WeebleWobble - but the dealer did something I never experienced before - they asked if I minded that they take MINE for a test ride - 2014 with 2500 miles? why? its new? I just don't like it? Hmmm... now im worried - so they come back - service guys whispers some crap to the dealer - dealer sits down and scribbles some crap - $25,000 trade in - for a 2 month old $46,000 truck. and wont budge, wont argue, wont deal. I understand some loss due to being a one owner vehicle now and all, but damn... Reason? cause " im going to have to resell that" - think the word is out boys.......

Posted (edited)

Wow.... did he feel the shake or say anything about it after driving it? What speed does the truck shake @?

Edited by mafd2
Posted (edited)

Well, tired of my 2014 Chevrolet Viberado LT - went shopping for new trucks just to see how they ride ect ect. Came out of a 2004 Titan SE off-road, and really like the 2014 Titan Pro-4X - took it for a test ride and rides nice - so now the money issue comes up - willing to take a bit of a loss to get out of this over engineered WeebleWobble - but the dealer did something I never experienced before - they asked if I minded that they take MINE for a test ride - 2014 with 2500 miles? why? its new? I just don't like it? Hmmm... now im worried - so they come back - service guys whispers some crap to the dealer - dealer sits down and scribbles some crap - $25,000 trade in - for a 2 month old $46,000 truck. and wont budge, wont argue, wont deal. I understand some loss due to being a one owner vehicle now and all, but damn... Reason? cause " im going to have to resell that" - think the word is out boys.......

Don't be surprised. Dealers often get suspicious when one is trading in a nearly new vehicle. Still at least $ 30k should have been the lowest offer considering the outrageous sticker prices on these trucks. And I suspect too that the word is out - they have probably seen quite a few irate customers who bought these trucks slightly used and now cannot get them fixed even though they are still under GM factory warranty.

 

GM completely dropped the ball on the quality control on these trucks it seems - now they have badly assembled differentials, transmissions, drive shafts, and poorly assembled trucks in general. Even though I own 3 GM cars and trucks, I will not buy another GM truck at this point until I see a complete turnaround. My 2013 Chevy Sonic turned out to be an excellent little car with absolutely no problems, now at 21k miles. Has never been back to a dealer even for an adjustment. Even the wheel alignment was perfect out off the factory, which is not usual for GM cars and trucks (based on my experience with other two).

Edited by pm26

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • I am guessing that engines of that design back then had a better ability to be abused and survive longer than a new design engine with the long timing chain and the overhead cams and phasers etc. But I would never guess that an engine could go that far and not fail spectacularly or at least die a slow death. 
    • In the 80's 90's I'd run Honda's 7,500 miles between changes using Red Line HP 5W20 and do it for hundreds of thousands of miles with issues. Back in the day it was an SAE 20 with the HTHS of a SAE 30 and SN add load. It was also very polar. Oxidation VOA was over 120. Besides those motors were SPFI and lean burn tech. I could have likely run it longer but never did.    We had a Toyota bought new I ran on Pennzoil's latest and greatest synthetic of the day with "Penthane". A made up word for a very low dose of PAO. Tried 7,500 mile OCI's in that Group III/VI chemistry and the rings tapped out at 90K. Rocker box wasn't as bad as the one Punch put up but it wasn't good either. Also a SPFI motor.    I'm around 3,750 across the board on these GDI monsters and the oil it tapped out by then usually on TBN/TAN crossover and color. Red Line HP Euro.    The AMSOIL SS brochures tell you to follow the OEM values for the service class but that it can be run up to 25K if monitored. I can't imagine what motor could go that distance and not tap out. I've never owned one.    Yes, I know. Lot's of people do. I'm just not going to be one of them. 
    • I knew a guy in the early 80's that bought a new Monte Carlo and ran it a 100,000 miles without ever changing the filter or the oil. Just kept adding. It looked like that inside.     
    • Good evening. I was lucky enough to get passed down to me a 2007 GMC LBZ that was my great uncle's. While the underside and rockers are more or less gone I feel like with time I can restore it to working order since it only has 110,000 miles and he put nearly every option he could get without getting the new body style since he did not trust DEF. So far I have done everything I can think of but when I put the key into the ignition nothing happens. I put 2 brand new batteries in it. Cleaned the terminals. Check all the fuses and relays and they all pass with my multimeter. I know I'm missing something that I just cant think of. The only odd thing is the OBD2 port works which makes me think its not the mega fuse. Any advice would be greatly appreciated. 
    • Looks nice. I still have my 2000, 1500. Bought a 2025, 1500 for retirement. Feels solid. These trucks have a bad rap on the internet. My brother has a `24 1500, 5.3 with 52,000 miles. No problems at all. Mine hasn`t either but mine`s only at 12,700 miles. Have seen some of these things with 100,000 miles with no problems.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...