Jump to content

Recommended Posts

Posted
On 4/10/2020 at 2:03 PM, lryfer said:

Is this happening to the 2018 models as well?  I haven't seen that year mentioned. 

 

I used POR-15 in the past on my 66 GTO frame and under the body when it was off.  

Absolutely, yes. 18’s are not immune...I have an 18, I have to undercoat it twice a year to keep it from rusting.

Posted
On 4/13/2020 at 11:23 AM, Doublebase said:

Absolutely, yes. 18’s are not immune...I have an 18, I have to undercoat it twice a year to keep it from rusting.

This is such a pain, I've had 2 Toyotas, both which had the frames replaced for free while out of warranty. Are these frames even available separately or do I just toss the truck when the time comes?

 

From another former LS owner, these things seem like a catastrophe considering the truck is still in warranty and I've got frame rust, on my 2nd rear cam repair, transmission/powertrain issues etc. It's hard to accept then I read what the 8-speed Canyon folks are going through..

Posted
On 4/17/2020 at 12:21 AM, Locom0tive said:

This is such a pain, I've had 2 Toyotas, both which had the frames replaced for free while out of warranty. Are these frames even available separately or do I just toss the truck when the time comes?

 

From another former LS owner, these things seem like a catastrophe considering the truck is still in warranty and I've got frame rust, on my 2nd rear cam repair, transmission/powertrain issues etc. It's hard to accept then I read what the 8-speed Canyon folks are going through..

To be totally honest with you, I think your frame will last at least 15 years even if it does get totally covered in rust. As ugly as these chevy frames end up looking, I've only seen one that needed replacement (rusted through with a hole in it). 

 

Toyota's on the other hand, yeah I have seen quite a few totally destroyed.

 

I just keep up with my frame because I can't stand the sight of frame rust...drives me nuts. I imagine at some point I'll probably tire of keeping up with it, but I figure until then I'm adding years of life to the frame/truck by doing it.   

  • 7 months later...
Posted

What is the consensus of what most are doing to “keep up with” or treat theyre frames. Is the Lanolin fluid film or wool wax right over the existing wax coating the way to go and just deal with what it does the wax. I’ve had my 18 silverado 2 years now and want to do something. From what I gather we could imagine the wax coating as not even being there and treat accordingly?

Posted

I just picked up a 2016 Silverado WT from PA.  I'm in WI, the entire frame was devoid of all the factory wax.  Nothing left.  I went with the Rustoleum Rust Reformer.  Took a wire wheel cone and some wire brushes and got all the loose stuff off and then hit it with the Rust Reformer.  It dried to a nice flat black that was very similar to what the factory coat looked like new.  Definitely need 2 or 3 coats in some spots, it soaks into the rust in heavy areas.  My guess is that I will have to recoat every year, but it appears breathable and it does not have any rubber which should make for an ideal coating.  

 

https://www.rustoleum.com/product-catalog/consumer-brands/stops-rust/rust-reformer

  • Like 1
  • 1 month later...
Posted (edited)

I also use the rust reformer to touch up the rust spots, and then, I hit those spots with Rustoleum Pro Grade undercoating. Boxed frames usually rust through from the inside since they hold moisture and they can’t be re-coated inside. A friend recently had to park his 2000 Silverado due to the frame rusting through from the inside. He had coated the frame with POR15 several years ago. After researching different fluids to prevent rust, I decided to use ATF to coat the inside of my frame and cross members. It’s thin enough to spray without thinning and it appears to contain corrosion inhibitors. From the places it got on the outside of the frame, it seems to wick and spread fairly well which means it should do a good job of coating places not directly sprayed. I used an old bottle of Dexron III that I wasn’t going to use anyway. 

 To spray the ATF, I used a rechargeable sprayer that is pressurized with compressed air. I used a 2 ft spray tube that came with the cans of cavity wax that I sprayed inside my doors, rockers, fenders, tailgate. There are enough holes in the frame that I believe the entire frame is coated inside. The ATF seems to be friendly to the factory coating as I have seen no evidence of it pealing or softening as I’ve heard mentioned from folks using Fluid Film. Time will tell if my small investment in time and money was worth it as I plan to keep this truck for a while. 

4E04E3C5-BCA2-4570-B5A9-9DD8B384746B.jpeg

Edited by HoosierZ
  • 5 months later...
Posted

2018 Sierra, 30K miles - in addition to the rusting frame, which seems to be addressed in a service bulletin, has anyone experienced rear shock rust and color fading? The upper shock is now pink and lower portion is rusted so not very attractive. In quick search, it seems that the frame rust issue is largely cosmetic and involves an isolated # of K2 trucks. Wondering if they are all trucks out of a specific plant or geography? Was even thinking maybe flood/salt water (Hurricane Harvey or similar). Any insight would be appreciated. 

Frame rust.jpg

Frame rust2.jpg

Frame rust3.jpg

Frame rust5 shock.jpg

  • Like 1
  • 3 months later...
Posted
On 6/20/2021 at 1:56 PM, JvanGroup said:

2018 Sierra, 30K miles - in addition to the rusting frame, which seems to be addressed in a service bulletin, has anyone experienced rear shock rust and color fading? The upper shock is now pink and lower portion is rusted so not very attractive. In quick search, it seems that the frame rust issue is largely cosmetic and involves an isolated # of K2 trucks. Wondering if they are all trucks out of a specific plant or geography? Was even thinking maybe flood/salt water (Hurricane Harvey or similar). Any insight would be appreciated. 

Frame rust.jpg

Frame rust2.jpg

Frame rust3.jpg

Frame rust5 shock.jpg

 

You can't stop rust once it's started. Unless you grind it off. 

 

Use rust cure 3000, rust check etc. 

  • 1 month later...
Posted

It wasn’t structurally damaged, looked worse than reality.  The flaking undercoating was the messy part.  I’ll just check it each spring and clean it up.

 

just sucks GM won’t use a durable metal treatment.

  • Like 1
  • 11 months later...
Posted (edited)

2015 Sierra. Original wax coat.  5FC08500-7BFE-4668-9C22-24CAEF1C608F.jpeg

F6F0D845-FFB8-4891-B88C-26AC084D422E.jpeg

DF05FB4D-9D6A-438E-9761-AF51ABB2BD82.jpeg

7833387D-FFD8-493A-93C4-BA30DEE7FB27.jpeg

3B6FA5AB-CD62-4862-A9A5-971FAA470FD2.jpeg

A666A8E8-5D7C-4A0C-80DB-D306B6411E78.jpeg

Edited by K2XX
  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • not all plugs will be used.  gm uses more generic harnesses that support most/all options, and if your truck doesn't have a specfiic option, the plug won't be used (commonly will have a dummy insert in the plug , or it'll be taped up, but some may just be left as is).  But it's sldo possible some p.o. has installed the wrong/cheaper parts that aren't correct for your vehicle...
    • First off, I'm not trying to just get easy advice/fixes for the issues I've noticed so far.  I'll be combing through the site via searches and such, and if past experiences are any indication, should find what I need.  For the sake of conversation, though, I figured I'd post the handful of things I've noticed in the 12 hours since buying my 2010 SLE CCSB.     Indicator lights: Airbag and TPMS.  The tire pressures aren't reading for any of the wheels, so I'm pretty certain the sensors were either removed, are damaged, or are otherwise inoperable.  I used to mount and balance tires 25 years ago but am pretty much ignorant when it comes to TPMS.  My 2006 didn't have the sensors and this might be the fourth vehicle I've owned that does.     Radio: Rear speakers aren't working.  I removed the driver's side rear door panel and checked the speaker and wiring.  I also removed the sill and b-pillar covers to check the wiring.  A few minutes of Google Fu showed that this is potentially a head unit issue.    Switches: Power mirrors don't turn left/right.  I ordered replacement driver's door switches that should arrive tomorrow.  The windows and locks work but it was only about $20 for all of them.  The driver's side rear window switch lets the window down but won't put it back up.  I think the passenger rear doesn't work at all.  In the coming days/weeks, I'll break out my multimeter to check all of that.   Unknown wiring harness: There's a box attached to the front driver's side of the engine compartment, right where the second battery shelf is located.  There are three plugs, one of which looks like it fits a standard headlight-style bulb (9007 or similar).  It doesn't look like it's plugged into anything.  I'll do some digging and if I don't see anything elsewhere on the site, post some pictures here.   Unknown plugs on brake booster: There are at least two female plugs on the brake booster that aren't being used.  I think it might be a replacement/aftermarket, so maybe those are used for a different application, as there don't seem to be any unplugged harnesses and no indicator lights are on.   Little squeaks when turning: Sounds almost like a bushing around the bed of the truck.  I'll have to pay close attention as I get more familiar with the truck.   Clunk on acceleration: possibly the infamous drivetrain clunk.  My 2006 had it and I'm just not familiar enough with this truck yet to fully grasp what it is.   Anyway, my apologies for the vague and all over the place post.  This truck is new to me, and it's been four years since I drove my 2006.  With 200k miles, I know I'll need to learn this truck quickly to avoid having any major issues, despite being confident it's got much more life to it.  My 2006 had nearly 320k on it when I parked it (nearly 300k of which I put on the truck), and it was still drivable then, though I suspected the head gasket might have blown.  I'd hoped to have that truck back by now, but it's gone forever, as I detailed in my reintroduction thread.  
    • I always drive in Sport mode. With more driving, I am finding the initial response when accelerating is much quicker now🖕 Lou
    • Is it an optical illusion in the pic or is the truck really squatting that much horribly?
    • My initial introduction was here.  It's hard to believe that I last posted in February 2013, having just deployed to Kyrgyzstan.  Since then, I've retired from the military and the 2006 Sierra SLT Z71 that first brought me to these pages was lost.  I went forward to Afghanistan in March 2013 and did a lot of sitting behind a computer on brigade staff.  Within 18 months of getting back to the States, I was selected for Drill Sergeant duty, after which I moved back to Virginia (my home state and where I served from 2004-2008).  That '06 Sierra did a lot of driving between Louisiana, Georgia, and Virginia, and ended up with nearly 320k miles by 2022.  By then, the registration had been expired for a couple of years, but the pandemic had all but eliminated tickets for such transgressions.  Admittedly too, I usually drove my wife's SUV or son's car the 2-3 times a week I had to report to work.  Teleworking sure was fun while it lasted.   I started my retirement leave four years ago and stored the Sierra at my sister's house.  A big mess was made when her fiancé passed while she was taking care of business out-of-state in late-2024, and his son pretty much mismanaged everything to do with the estate.  Even so, I was assured that my truck was safe... until it wasn't.  I found out that my truck had been scrapped about four months after the son took over everything.  There's nothing I could do; I'm 1000 miles away and it was technically abandoned property since he'd even trespassed my sister from her own house (she had no claim to it as she wasn't married, and the fiancé was the sole owner).     Anyway, today I got my second Sierra.  This is a 2010 SLE 2WB CCSB with a little over 200k miles on it.  It's got the 5.3L I'm familiar with and should handle what I need it for.  Hauling stuff that won't fit in the Transit Connect (yep, I sold out, but that's the wife's vehicle) and towing a few times a year tops.  The price seemed decent, considering how much people sell their trucks for in the Deep South: $4500.  I've seen similar trucks listed for more than double that.  I got it from a coworker who left his tag on until we transfer the title next week (Louisiana requires a notary for transfers), so I've been driving it all day.  The rear speakers don't work, which is one of the things that brought me back to these forums earlier.  I can't say how active I'll be as a poster, but I'll be scouring the archives while I find out every little thing I can about the 2010s and particular nuances/problems with my truck.   It's definitely not a GMC, but I got another Willys Jeep a few months back as well, so I'm almost at the same place I was when I first joined gm-trucks.com.  My old 1960 DJ3A was sold back around 2010 or 2011; my current Jeep is a 1946 CJ2A.  So, I've got a slightly newer GMC and a much older Jeep.  I kind of wish I still had that F-250 I had way back when too.  The Dakota is long gone and was technically my brother's truck, though I had it registered and insured.  The F-250 had to go when my grandmother's house was foreclosed on due to mismanagement around 2012 or so.     Hopefully anyone that made it this far isn't too annoyed.  I tend to be long-winded, but I'll be doing more reading than posting in the coming months.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...