Jump to content

Recommended Posts

Posted
On 4/10/2020 at 2:03 PM, lryfer said:

Is this happening to the 2018 models as well?  I haven't seen that year mentioned. 

 

I used POR-15 in the past on my 66 GTO frame and under the body when it was off.  

Absolutely, yes. 18’s are not immune...I have an 18, I have to undercoat it twice a year to keep it from rusting.

Posted
On 4/13/2020 at 11:23 AM, Doublebase said:

Absolutely, yes. 18’s are not immune...I have an 18, I have to undercoat it twice a year to keep it from rusting.

This is such a pain, I've had 2 Toyotas, both which had the frames replaced for free while out of warranty. Are these frames even available separately or do I just toss the truck when the time comes?

 

From another former LS owner, these things seem like a catastrophe considering the truck is still in warranty and I've got frame rust, on my 2nd rear cam repair, transmission/powertrain issues etc. It's hard to accept then I read what the 8-speed Canyon folks are going through..

Posted
On 4/17/2020 at 12:21 AM, Locom0tive said:

This is such a pain, I've had 2 Toyotas, both which had the frames replaced for free while out of warranty. Are these frames even available separately or do I just toss the truck when the time comes?

 

From another former LS owner, these things seem like a catastrophe considering the truck is still in warranty and I've got frame rust, on my 2nd rear cam repair, transmission/powertrain issues etc. It's hard to accept then I read what the 8-speed Canyon folks are going through..

To be totally honest with you, I think your frame will last at least 15 years even if it does get totally covered in rust. As ugly as these chevy frames end up looking, I've only seen one that needed replacement (rusted through with a hole in it). 

 

Toyota's on the other hand, yeah I have seen quite a few totally destroyed.

 

I just keep up with my frame because I can't stand the sight of frame rust...drives me nuts. I imagine at some point I'll probably tire of keeping up with it, but I figure until then I'm adding years of life to the frame/truck by doing it.   

  • 7 months later...
Posted

What is the consensus of what most are doing to “keep up with” or treat theyre frames. Is the Lanolin fluid film or wool wax right over the existing wax coating the way to go and just deal with what it does the wax. I’ve had my 18 silverado 2 years now and want to do something. From what I gather we could imagine the wax coating as not even being there and treat accordingly?

Posted

I just picked up a 2016 Silverado WT from PA.  I'm in WI, the entire frame was devoid of all the factory wax.  Nothing left.  I went with the Rustoleum Rust Reformer.  Took a wire wheel cone and some wire brushes and got all the loose stuff off and then hit it with the Rust Reformer.  It dried to a nice flat black that was very similar to what the factory coat looked like new.  Definitely need 2 or 3 coats in some spots, it soaks into the rust in heavy areas.  My guess is that I will have to recoat every year, but it appears breathable and it does not have any rubber which should make for an ideal coating.  

 

https://www.rustoleum.com/product-catalog/consumer-brands/stops-rust/rust-reformer

  • Like 1
  • 1 month later...
Posted (edited)

I also use the rust reformer to touch up the rust spots, and then, I hit those spots with Rustoleum Pro Grade undercoating. Boxed frames usually rust through from the inside since they hold moisture and they can’t be re-coated inside. A friend recently had to park his 2000 Silverado due to the frame rusting through from the inside. He had coated the frame with POR15 several years ago. After researching different fluids to prevent rust, I decided to use ATF to coat the inside of my frame and cross members. It’s thin enough to spray without thinning and it appears to contain corrosion inhibitors. From the places it got on the outside of the frame, it seems to wick and spread fairly well which means it should do a good job of coating places not directly sprayed. I used an old bottle of Dexron III that I wasn’t going to use anyway. 

 To spray the ATF, I used a rechargeable sprayer that is pressurized with compressed air. I used a 2 ft spray tube that came with the cans of cavity wax that I sprayed inside my doors, rockers, fenders, tailgate. There are enough holes in the frame that I believe the entire frame is coated inside. The ATF seems to be friendly to the factory coating as I have seen no evidence of it pealing or softening as I’ve heard mentioned from folks using Fluid Film. Time will tell if my small investment in time and money was worth it as I plan to keep this truck for a while. 

4E04E3C5-BCA2-4570-B5A9-9DD8B384746B.jpeg

Edited by HoosierZ
  • 5 months later...
Posted

2018 Sierra, 30K miles - in addition to the rusting frame, which seems to be addressed in a service bulletin, has anyone experienced rear shock rust and color fading? The upper shock is now pink and lower portion is rusted so not very attractive. In quick search, it seems that the frame rust issue is largely cosmetic and involves an isolated # of K2 trucks. Wondering if they are all trucks out of a specific plant or geography? Was even thinking maybe flood/salt water (Hurricane Harvey or similar). Any insight would be appreciated. 

Frame rust.jpg

Frame rust2.jpg

Frame rust3.jpg

Frame rust5 shock.jpg

  • Like 1
  • 3 months later...
Posted
On 6/20/2021 at 1:56 PM, JvanGroup said:

2018 Sierra, 30K miles - in addition to the rusting frame, which seems to be addressed in a service bulletin, has anyone experienced rear shock rust and color fading? The upper shock is now pink and lower portion is rusted so not very attractive. In quick search, it seems that the frame rust issue is largely cosmetic and involves an isolated # of K2 trucks. Wondering if they are all trucks out of a specific plant or geography? Was even thinking maybe flood/salt water (Hurricane Harvey or similar). Any insight would be appreciated. 

Frame rust.jpg

Frame rust2.jpg

Frame rust3.jpg

Frame rust5 shock.jpg

 

You can't stop rust once it's started. Unless you grind it off. 

 

Use rust cure 3000, rust check etc. 

  • 1 month later...
Posted

It wasn’t structurally damaged, looked worse than reality.  The flaking undercoating was the messy part.  I’ll just check it each spring and clean it up.

 

just sucks GM won’t use a durable metal treatment.

  • Like 1
  • 11 months later...
Posted (edited)

2015 Sierra. Original wax coat.  5FC08500-7BFE-4668-9C22-24CAEF1C608F.jpeg

F6F0D845-FFB8-4891-B88C-26AC084D422E.jpeg

DF05FB4D-9D6A-438E-9761-AF51ABB2BD82.jpeg

7833387D-FFD8-493A-93C4-BA30DEE7FB27.jpeg

3B6FA5AB-CD62-4862-A9A5-971FAA470FD2.jpeg

A666A8E8-5D7C-4A0C-80DB-D306B6411E78.jpeg

Edited by K2XX
  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • On the subject of OLM, Gm's OLM tool may be more "informed" than others brands. I recall OLM's in mid-2000's Chrysler products literally counting down a set number of miles. That's all the OLM appeared to be.    I would actually expect GM to be able to explain the parameters that their OLM takes into account from a high level. No, I would not expect them to disclose their software coding or data analysis around their parameters.   So we're talking about two different topics, so to continue the subject on the other one, I'd be curious to know how much "standard particulate matter" in fresh oil is able to be filtered at first start by a fresh oil filter. How much particulate matter is enough to "matter"?   I.e. how much of a "lever" do we think this equates to (variability in particulate content, in fresh oils, between different makes/brands, some which filter less, and some that filter more).   We can say that more particles = more wear = shorter engine life as a logical statement and use that data with a little marketing to scare people into selecting a more refined/filtered oil. Using a similie, is this like deciding to forego two alcoholic drinks in a lifetime because we're worried about the potential impact on lifespan? Are there numbers which translate the ISO test results into a quantifiable increase in wear for a given engine/use case?
    • I'm pretty sure it doesn't actually recalibrate the speedometer it just changes the wheel speed sensor inputs to the computer. The truck still thinks it has stock tires.
    • I apologize, I missed this post, at risk of going off CURRENT TOPIC.   I'm not saying it is BS, I'm questioning how much information is being held back. GM is NOT going to spell out exactly every parameter in the algorithm. Liability, intellectual property, etc.    I'm not naive enough to believe that it is as simple as revolutions, coolant temperature, miles, time; are you?    I don't do irrational either, and boiling the OLM down to four simple values that I could code in an afternoon (I'm not a coder) is irrational - unless it suits your agenda to ignore it. 
    • Chris 21 I appreciate your constructive response. !!  😉😉😉   The 6.6 is gas.  Correct me if I’m wrong but by recalibrating the speedo you’re correcting the shift points of the transmission on these trucks.?.
    • That is a huge misconception.     Bigger does not always equal safer.  Modifying does not make it safer either, with exceptions.   Think of this.  Your truck in stock form is capable of emergency maneuvers, proper stopping distances, its handling is designed around the factory wheel/tire packages, etc.   37s and a lift?  Now you've affected your braking distances, handling and ride control.  You've raised your center of gravity higher.  Your front visibility is now obstructed more than stock, same for your rear.  Does it look cooler?  Yes.  Does it now work as good as it did from factory on road?  NO.       As for my mention of exceptions?  Say you had a sedan or crossover.  They typically come with all season tires.  If you swap out for a performance all season or a summer tire, you improve your car by lowering its stopping distance (better braking because of traction) and improve the handling (regular and emergency) of the vehicle.  That is an actually improving modification.  My old 2019 LD 1500, I ran UHP all season tires on 20in wheels in a factory offered size.  It improved all aspects of how it drove over the Duratracs it came with from the factory in the stock 18" tire.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...