Jump to content

2014+ K2XX - Center Console Swap / Retrofit - Plug and Play Harness!

pgamboa

By pgamboa
in Modifications & Accessories

 Share

Recommended Posts

zikronix Enthusiast

zikronix

Posted
Posted (edited)
16 minutes ago, frankinbus said:

Hey Phill We can do this just watched your video a shit load of times ,

I think i don't need a hmi box , we just come from under seat (usb) to input side of front double usb , come out from out going side to brown plug on front that feeds the console box , that picture i sent you of my  (vais xm)  plugged directley under seat works fine. still have car play ,

So i should order those usb cables unless you have them 

So i'll just need your power up wireing and the upgrade plug for wireless gharging pad ,

IMG_4960.JPG

I had this same thought me and scottnaz were going back in forth about this. Scott What ever happened with your usb issue?

Edited by zikronix
  • Replies 1.2k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

pgamboa
pgamboa

Jump Seat to Full Center Console Retrofit  Plug and Play Harness by PGAMBOA     For those of you looking to swap your Jump Seat to a Full Center Console, I now have a Plug and Play Harness

pgamboa
pgamboa
ChrisTaylor14
ChrisTaylor14

I waited a long time to do this upgrade on my truck because I didn’t want to have to cut and splice the wiring in my truck and wanted everything to work as if the console were factory. So when I saw t

Posted Images

frankinbus Enthusiast

frankinbus

Posted
Posted

I have a work/truck no hmi box , so i sure this way would work , if my xm works out of it 

zikronix Enthusiast

zikronix

Posted
Posted
I have a work/truck no hmi box , so i sure this way would work , if my xm works out of it 
Ahh...ok. Me and scottnaz have hmi boxes.

Sent from my Pixel 2 XL using Tapatalk

frankinbus Enthusiast

frankinbus

Posted
Posted

Thats cool , those truck should come with full consoles , i think the single cab looks awesome with the full , to old to have my sweetheart sit next to me anyway, lol 

manniel127 Enthusiast

manniel127

Posted
Posted

What if i don’t want to run the extra USB and 12 bolt plug? I’m going to install some rocker switches in their place. 

Nasty Senior Enthusiast

Nasty

Posted
Posted
30 minutes ago, manniel127 said:

What if i don’t want to run the extra USB and 12 bolt plug? I’m going to install some rocker switches in their place. 

Then you just don't hook those up. In that case I don't think you'll even need the harness

louiecr Enthusiast

louiecr

Posted
Posted

You need relays in new vehicals,  you can’t just put rocker switch in. You will fry the computer 

manniel127 Enthusiast

manniel127

Posted
Posted
7 hours ago, louiecr said:

You need relays in new vehicals,  you can’t just put rocker switch in. You will fry the computer 

N SPOD is being installed. 

manniel127 Enthusiast

manniel127

Posted
Posted
10 hours ago, Nasty said:

Then you just don't hook those up. In that case I don't think you'll even need the harness

Sorry, I didn’t finish my post. But you answered thanks. Only reason I would need it if I wanted to run the LED light right? 

 

Frank Jr Enthusiast

Frank Jr

Posted
Posted

SuperAllTerrain  I don't know maybe someone else can answer your question. Very possible that Phil might know.

Lsufan03 New Member

Lsufan03

Posted
Posted (edited)

Hi Phil,

I have a 2017 Silverado LTZ 4x4 and I’m upgrading to the full center console upgrade and I would like to purchase your PnP Harness please. Thanks! 

Edited by Lsufan03
jaykoz71 Enthusiast

jaykoz71

Posted
Posted

I have a 14 GMC Sierra will the charging doc work the same would it be an easy connect?


Sent from my iPhone using Tapatalk
Interested

Sent from my SM-G920V using Tapatalk

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...