Jump to content

2014+ K2XX - Center Console Swap / Retrofit - Plug and Play Harness!

pgamboa

By pgamboa
in Modifications & Accessories

 Share

Recommended Posts

Chard220 New Member

Chard220

Posted
Posted (edited)

Are these available for the 2018’s also do you have the harnesses without the 110v?

Edited by Chard220
  • Like 1
  • Replies 1.2k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

pgamboa
pgamboa

Jump Seat to Full Center Console Retrofit  Plug and Play Harness by PGAMBOA     For those of you looking to swap your Jump Seat to a Full Center Console, I now have a Plug and Play Harness

pgamboa
pgamboa
ChrisTaylor14
ChrisTaylor14

I waited a long time to do this upgrade on my truck because I didn’t want to have to cut and splice the wiring in my truck and wanted everything to work as if the console were factory. So when I saw t

Posted Images

pgamboa Senior Enthusiast

pgamboa

Posted
  • Author
Posted
Are these available for the 2018’s also do you have the harnesses without the 110v?

Yes - available for 2018. 2018s weren’t out yet when I made the video.

Harnesses are built the same with/without 110v. You’ll have a dead 110V if your truck didn’t come with it. You can also add the inverter and wiring to Gain it.


Sent from my iPhone using Tapatalk
Arrond New Member

Arrond

Posted
Posted

Is there anyone that has removed their jump seat and ashtray that would be willing to sell them?  I am looking for black leather for a 2015 LTZ.  I am located near Lexington, KY and would prefer something within driving distance if possible.

pgamboa Senior Enthusiast

pgamboa

Posted
  • Author
Posted
Do you offer the inverter and such with the harness?

When I get a dash take off, I usually pull the inverter and wiring and sell them for $150. If you PM me, I can add you to a wait list for one.


Sent from my iPhone using Tapatalk
pgamboa Senior Enthusiast

pgamboa

Posted
  • Author
Posted
Is there anyone that has removed their jump seat and ashtray that would be willing to sell them?  I am looking for black leather for a 2015 LTZ.  I am located near Lexington, KY and would prefer something within driving distance if possible.

I’ve got an ashtray trim I could sell ya. $60 shipped anywhere in the US. Comes with the 12V outlet and 110V outlet.


Sent from my iPhone using Tapatalk
Crewcab15 Enthusiast

Crewcab15

Posted
Posted
Is there anyone that has removed their jump seat and ashtray that would be willing to sell them?  I am looking for black leather for a 2015 LTZ.  I am located near Lexington, KY and would prefer something within driving distance if possible.

I got one off of a 15 Silverado lt I'm willing to sell but I'm in canton Ohio might be to far sell them both for $100 it's not leather but it is blackSent from my SM-N960U using Tapatalk

 

 

 

 

 

 

 

johnhankel Enthusiast

johnhankel

Posted
Posted
5 minutes ago, Arrond said:

Is there anyone that has removed their jump seat and ashtray that would be willing to sell them?  I am looking for black leather for a 2015 LTZ.  I am located near Lexington, KY and would prefer something within driving distance if possible.

A guy in Tennessee was looking to sell a leather jump seat..  Not sure if he got it sold or not...

johnhankel Enthusiast

johnhankel

Posted
Posted
6 minutes ago, johnhankel said:

A guy in Tennessee was looking to sell a leather jump seat..  Not sure if he got it sold or not...

I guess he already sold his...  Good luck...

14 Silvy Enthusiast

14 Silvy

Posted
Posted
Is there anyone that has removed their jump seat and ashtray that would be willing to sell them?  I am looking for black leather for a 2015 LTZ.  I am located near Lexington, KY and would prefer something within driving distance if possible.


I have a black leather jump seat took out of my 18 had 100 miles on it also have dash peice. I am in Frankfort my.


Sent from my iPhone using Tapatalk
Arrond New Member

Arrond

Posted
Posted
2 minutes ago, 14 Silvy said:

 


I have a black leather jump seat took out of my 18 had 100 miles on it also have dash peice. I am in Frankfort my.


Sent from my iPhone using Tapatalk

 

Just sent you a PM

  • 2 weeks later...
mjdannenberg New Member

mjdannenberg

Posted
Posted

Did this swap over the weekend.

 

Purchased all of the parts including the console from PGamboa. The console arrived very well packaged and was exactly what I asked for. The wiring harness followed quickly behind. Everything fit up and plugged in perfectly and was exactly as advertised. The harness is as good or better than OEM quality. I was legitimately impressed when I pulled it out of the box. The swap took me about 2 hours start to finish, but there were a couple of interruptions and my tools were a little scattered since that wasn't the first thing I tackled that day.

 

The only "gotcha" moment I had was mentioned earlier in the thread, and that is the trim panel that wraps around the driver's side dash support next to the accelerator pedal needs to be pulled off in order for the console trim panel to fit properly.

 

I would highly recommend Phil and his products. Everything shipped quickly and was of excellent quality. Now I just need to figure out what to do with the jump seat in my garage.

  • Like 1
Jhudelson New Member

Jhudelson

Posted
Posted

I’m interested in purchase of your plug and play harness for the center console swap

I have a 2018 Silverado LT and purchased a new 2018 center console. 

How do I proceed ?

johnhankel Enthusiast

johnhankel

Posted
Posted
2 hours ago, Jhudelson said:

I’m interested in purchase of your plug and play harness for the center console swap

I have a 2018 Silverado LT and purchased a new 2018 center console. 

How do I proceed ?

Send Phil a private message....  Very good to work with and he will get you set up...

Chev-mekanik Enthusiast

Chev-mekanik

Posted
Posted

If I didn’t have to ship across a border I would have done this long ago. Trying to source the console locally so all I have to get shipped is the harness. Maybe I should order harness now because of high demand? Hmmm....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Chuck FB
      Oil Consumption

      By Chuck FB · Posted

      So speaking of oil consumption with my L8T as I just changed the oil yesterday and made the switch over to Amsoil SS 0W-40 from the Mobil 1  5W-30 Truck and SUV I just dropped out. 2900 miles on that oil as well as  68 hours on that oil ( so used to equipment with an hour meter and that becomes valuable information to compare with others as well ). Once again the oil use was so very little, I am going to say it dropped under 1/16 of an inch on the dipstick. No towing was done and this interval was from early spring until now.    One interesting item to note is that going by the 5 quart jugs I was using before from Mobil, it was showing that I was putting in 8 US quarts to bring it to full if not slightly over the full mark according to their jug markings. Granted I did allow more drain time this time and in part because the engine oil was only lukewarm as I started it and let it idle and not for long enough to get the oil itself hot ( the engine was up to operating temp ). The oil in that state just seemed to take forever for it to drip out but not only at the drain plug but at the oil filter housing as well, perhaps I had never quite gotten all the oil out before and I could have still waited longer but as it was I waited well over 3 hours. I think next time if I have the time I will do an experiment by dropping the oil and lets say leave the pan under it for 15 minutes, then switch to another pail and let it drip out overnight and measure how much more oil comes out. So this time and yes I ended up getting it just over the full mark as I was experimenting with trying to get the level to the add mark after I had run it and then waited some and then added a bit and waited for a certain amount of time for it to settle to the add mark. I very well may not have waited long enough for that experiment but I got to the add mark, then dumped in a full quart and waited some and checked and then waited some more and it crept up more ... and then finally oops, it was slightly over full some hours later when it really had settled all it would. I find this engine sure takes time for the last bit of oil that gets poured in to finally make its way into the crank case. I can only guess at how much too much I added as per maybe a 1/10th of a quart. I had poured in 8.5 quarts going by the quart containers as per 8 quarts and 16 us ounces. I was shocked at how much this was off compared to the prior oil changes and if those larger jugs and they are not marked accurately enough or they contain slightly more than what they say, or the drain time factor made that much of a difference. But I know on this forum there have been others who have said they have put well over 8 quarts in their L8T and now I have also going by the Amsoil true quart containers. Its a confusing convoluted mess up here in Canada with some oil manufactures packaging is in true US quarts, some is also in true US quarts containers on an even number of quarts but also marked in liters which becomes the odd ball volume of a fractional amount of liters. Then there is the Liters only containers, no US markings as its a true metric container and only measured in Liters to an even number of Liters. But remember we used to have Imperial Gallons and Imperial quarts as well !. 
    • Atlas
      2027 GMC Sierra: Official Discussion

      By Atlas · Posted

      Holy smokes. Clearly not a deal on that truck. I just mean in general, matte or painted trim is becoming more normative than chrome, but I know the Black Optics packages on various vehicles are being sold as uplevel trims. They look really good, but sheesh. It's just paint and plastic.
    • Grumpy Bear
      Some Assembly is Required

      By Grumpy Bear · Posted

      I Wouldn't Know Where to Begin    Oh I know where I would begin but I'm just one of over eight billion people on this rock. Eight billion versions of where the goal post is. How large it should be. How far to kick from. What ball is the right ball. Elevation. Age.....are you getting the point? It isn't about disagreeing with one individual. It's about agreeing only with one individual. One's self.   Agreement comes when multiple people hold the same point already. THAT is the goal of an education. Building the Social Contract. That thing that allows us to all read this sentence. We've agreed on the alphabet and how to arrange those letters into words we agree upon whose meanings hold true for everyone entering into that contract. Those words arranged into a sentence form an idea and several sentences strung together in a paragraph convey an argument for or against or inform the reader of a state, condition or perhaps reveal a things nature. Paint a word picture. Make oneself known.    This contract is not limited to words although they are often explained by words. Things like numbers and their usefulness. Physics, Chemistry, Medicine, Music, Art and so on.    The frequency of middle C (C4) is 261.63 Hz is a first principle. We build on that to make music we all can enjoy even if we all can not compose or play. You don't have to master it to make it enjoyable and useful.    So why is the Beginning so difficult? Why is agreement so elusive?   Everyone "Signs" the contract (when receiving that education in obtaining it)  but fewer and fewer in this world have any intention of living by that contract. They find exploiting that contract more advantageous. Disruption. With intent. Without intent. In Ignorance. In your face. With a double dog dare you. With a hold my beer. In resistance to that contract and in spite how it looks on us. It permeates the very air we breath.    In this way the contract is subject to advantage. Abide by it when it serves you, disregard it when it doesn't. Unpredictable and self-serving. Corrosive.....Toxic........   It says a lot about a persons character to disregard the contract, the truth, first principles. None of it good.        ********************************************************   https://medicine.yale.edu/news-article/character-vs-personality-who-we-are-and-who-we-aspire-to-be/   Just an interesting article.   
    • Jus Cruisin
      2027 GMC Sierra: Official Discussion

      By Jus Cruisin · Posted

      It costs $5,250 for the Yukon Nightfall option (black wheels, emblems and illuminated black GMC grill badge). What a "deal". 
    • Ralph Reale
      Android auto could not connect

      By Ralph Reale · Posted

      I keep getting the above error message on my 25 Sierra.  If I reset the infotainment unit (via the phone hang up button) it will work again for a day or 2.   But I dont want to do have to reset  all the time. Works fine in my 2023 Corvette. On both vehicles I connect wirelessly.   I have a Google Pixel 10 Pro XL, phone is up to date.  Any Ideas.  See attached  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...