Sign up for FREE! Become a GM-Trucks.com Member Today!
In 20 seconds you can become part of the worlds largest and oldest community discussing General Motors, Chevrolet and GMC branded pickups, crossovers, and SUVs. From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience.
I decided I would make a listing of the all time best Government Motors trucks of all time. I HOPE YALL ARE AWARE THAT THIS IS JUST MY OPINION. BUT I KNOW FOR A FACT THAT THIS LIST IS DAMN NEAR PERFECT. I know this because I am a Chevrolet enthusizt.
List going from best to worst:
1) T1XX-easily the best gm truck gm has ever designed. I love my rst and am thinking about a trail boss due to my love of spacer lifts.
2) GMT400-kinda hot tbh it’s just a lil’ uglee
3)K2XX-I like the Z71s and Custums
4) Squarebody-not bad...just a lil’ too square lol
5) gt900-so hot and reliable af. Honestly I put this above Squarebody.
6)trucks made in late 60s to before squarebody (idgaf what they’re called...Dey ugly tho😂😂😂)
honorable mention: el Camino is May B best truck of all time in my correct opinion
Hi everyone, I have been working on a 1997 Chevy 1500 WT. I just happened to be working under the dash and noticed that the green wire that goes into the firewall harness connection was disconnected. Does anyone know what this green wire is for? (please refer to photo below) I looked at the wiring diagram and it looks like it goes to the MAF which I think is for the speedometer operations. Now my second question is, if it is for the MAF where should I try to reconnect. I obviously can't get it back into the bulkhead. Can I bypass the bulkhead and run a jumper wire?
I would be appreciative for any help.
I dropped a 1988 big block in my 1986 Blazer and went thru the timing chain. Put all back together as always. Tried to fire it up and backfire thru carb. So figured 180 out. Pulled the dot towards each other and re dropped the distributor in and set all up. Still getting same.... I am a seasoned mechanic getting my butt kicked. Help. Thanks.
Recently Browsing 0 members
No registered users viewing this page.
Most OnlineNewest Member
Who's Online 54 Members, 0 Anonymous, 1,068 Guests (See full list)
- 2003 SSEi
- Travis Goodwin
- MTU Alum
- Booger T
- Country Bumpkin
- U.P. rider
- Robert tam
- BO TIE 1
- Ralph Mendez
- O Town Denali
- morris washington
- Jim Callahan