Jump to content

Recommended Posts

Posted

Wow that's lot of bad tires if u ask me. (Lol)

My guess is they are all good year tires, Someone at GM should be pi$$ed with all the vibration troubles.

Posted

While my truck was at the dealer they gave me a 2014 tx edition with 500 miles as a loaner with continetal tires and it had the same vibration.. I think they don't know what the problem is so they blame the tires ... I ran the same goodyear tire on my 2008 sierra tx edition and had no problems at all. ( And why would they have my dealer shim my motor mounts with washers) A $38000 dollar truck with washers on the motor mounts...

  • Like 1
Posted

Wow that's lot of bad tires if u ask me. (Lol)

yes it is mostly tires or the poor balancing of such. All new tires will ride much better if trued by someone that knows how to properly true a tire and high speed balance on the car/truck. A new truck here or there may have mechanical issue but most vibs in steering wheel and seat are the result of tires and balancing. All tires are out of round some and weight too. It is a matter if enough to cause a ride problem even with a good balance.

 

If I were one of the unfortunate here with the vibration problem, I would start with the tires. And not at the dealership. Then with good tires and balance and still a problem go back to the dealer. Let the dealer know about the vib problem and take their shot and then if not fixed, let them know you are going to replace the oems. This way they cannot say well it is those new Michelins....

 

Unless it comes with Michelins, to me replacing oem tires is just a mod that should be done as soon as possible. Same with shocks.

Posted (edited)

My guess is they are all good year tires, Someone at GM should be pi$$ed with all the vibration troubles.

They must have got a really good deal on a train load of these lousy tires. Which in the end was a very bad deal after all. Or, there is another problem somewhere and they have no idea what.

Edited by pm26
Posted

yes it is mostly tires or the poor balancing of such. All new tires will ride much better if trued by someone that knows how to properly true a tire and high speed balance on the car/truck. A new truck here or there may have mechanical issue but most vibs in steering wheel and seat are the result of tires and balancing. All tires are out of round some and weight too. It is a matter if enough to cause a ride problem even with a good balance.

 

If I were one of the unfortunate here with the vibration problem, I would start with the tires. And not at the dealership. Then with good tires and balance and still a problem go back to the dealer. Let the dealer know about the vib problem and take their shot and then if not fixed, let them know you are going to replace the oems. This way they cannot say well it is those new Michelins....

 

Unless it comes with Michelins, to me replacing oem tires is just a mod that should be done as soon as possible. Same with shocks.

Balancing tires properly is a neverending problem. Tires on my '09 Impala LTZ are difficult to balance for some reason and usually it takes three tries to get them balanced perfectly. I get a smooth ride for 20k miles if they are done right, so I know the tires are good. Generally the larger the tire diameter, the more difficult they are to balance properly. And cars are typically more sensitive to improperly balanced tires than trucks.

Posted

Well it has been about 200 miles since the dealer swapped the goodyears for Bridgstones and yes the wobble is gone, but I have to say this is the worst truck ever. The steering wheel is not smooth there is a constant slight vibration that is not tire related and even the smallest cracks in the road feel like you are hitting giant pot holes and the whole truck bounces. Every little thing is felt directly through the steering wheel.

 

If anyone is reading this post DO NOT BUY ONE OF THESE!!! I have had at least 10 chevy and GMC trucks and never had such an awful time driving a vehicle as this one. Can't wait to trade out of it.

I typically never buy first year redesigned vehicles, no matter what the make and model. They all seem to have some issues, some worse than others. But these vibration problems are very frustrating.

 

Have tried running slightly lower pressure in your tires to see if the ride is less harsh? I mean 2 to 4 psi less, anything beyond that may be unsafe.

Posted

Just had my 2014 Silverado Crew Cab4x4 6'6 " box 3.42 rear end to dealer for vibration but this happens at approx 30 mph at 3000 rpms under moderate to heavy acceleration coming out of a turn but they couldn't duplicate it. I also have noticed the tach surging when in 4 cyl mode at 1000-1200 rpms when going up slight incline but forgot to mention it to them. Have not noticed the vibration at 60 mph and up and I have Goodyear tires not sure which model. 3100 miles on truck but I have a topper so maybe the extra weight of that makes it not noticable. I also complained about a large hesitation when going up hill, letting off gas then trying to accelerate. The truck will do nothing to accelerate for at least a second (seems like forever) then will take off like nothing happened. Only happened twice. The dealer said it normal so the trans gears don't slam into each other. I think otherwise.

Posted (edited)

I just bought a 2014 Silverado, with the former "extended" cab setup, 5.3 l engine,18 inch wheels, Goodyear tires. I'm thinking I should have run away...when I first drove the vehicle, on the interstate, I said out loud to the salesman and my wife "it has a vibration." Thinking it was just an unbalanced tire, I went ahead and purchased the truck. Now, the dealer has force balanced all the tires, which did not solve the problem. The service manager has agreed that there is a vibration, but he and a technician drove other trucks of the same configuration under the same circumstances - about 65 to 72 mph - and they all had the same vibration. I am not happy with Chevrolet...These vehicles are advertised as being quiet and so forth...not so. I am not a happy camper. I won't be able to speak again with the dealer until next week. A poor vehicle. I will pursue my options now, with the things I've seen here.

Edited by Springmilld
  • Like 1
Posted (edited)

I just bought a 2014 Silverado, with the former "extended" cab setup, 5.3 l engine,18 inch wheels, Goodyear tires. I'm thinking I should have run away...when I first drove the vehicle, on the interstate, I said out loud to the salesman and my wife "it has a vibration." Thinking it was just an unbalanced tire, I went ahead and purchased the truck. Now, the dealer has force balanced all the tires, which did not solve the problem. The service manager has agreed that there is a vibration, but he and a technician drove other trucks of the same configuration under the same circumstances - about 65 to 72 mph - and they all had the same vibration. I am not happy with Chevrolet...These vehicles are advertised as being quiet and so forth...not so. I am not a happy camper. I won't be able to speak again with the dealer until next week. A poor vehicle. I will pursue my options now, with the things I've seen here.

I think your issue is "Dealer force balanced" Key word is Dealer. Take it to a reputable tire specific store and have them do it. It's apparent that GM and it's dealers either don't have the proper equipment/ training or both.

 

Either that or demand they change the tires to another brand other than Goodyear.

 

Just my .02

 

Mike

Edited by mzodarg
  • Like 1
Posted

I don't think its the tires unless they are not balanced properly. I have been reading the thread about the vibration and possible tire issue. We have two 14 LTZ Silverado 4x4 short bed crew cabs in our house hold. Both have the 20 chrome rims with 275 55 20 Wrangler SRA tires. Neither have any type vibration at all up to 90 mph and are as quiet as a church mouse. That's as fast as I have been. One truck has 4,000 miles and the other close to 2,000 miles on it.

Posted

I would not expect a dealership to be able to properly balance a tire in 30 mins or 30 days. find a good tire shop. Then you will know: 1. it is the tires or 2. it is not the tires.

 

A good shop can tell you if it is too far out to balance. Then new tire. A really good tire shop can true a tire and high speed balance on the auto. A really good shop like this is hard to find but if you do put them on your Christmas list.

 

Again, replacing OEMs and a good balance job should be considered a mod and not play lets beat up the dealership tell they give me new tires that they cannot balance either. Good luck guys.

Posted

Springmilld,

 

Hello! I am sorry to learn that you are experiencing an issue with your vehicle. I would like to look into this concern for you. Could you private message me referencing this tread including your contact information, VIN, current mileage, and preferred dealership?

 

Jennifer T.

GM Customer Care



  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Hello hello looking forward to expanding my knowledge of the 2026 2500 HD that I just bought.   Truck has 3500 miles on it four-wheel-drive crew cab and I’m about to put a 6 1/2 inch BDS lift on it 18 x 10 -25 offset with 37’s   Already have the wheels and tires just waiting on the lift install in about three weeks   Question what surprises am I not gonna be happy with?  I’m not new to lifted trucks so I know that acceleration towing gas mileage all that is affected..   Question is those of you that have this truck this powertrain with a 10 speed Allison and have done the mods that I’m doing,,, how bad is it? Is that Allison constantly gonna be hunting for the right gear to go into? And what about towing, acceleration, fuel consumption as mentioned?    Lastly how come I can’t find any ring pinion gear set up for these axles and when could I expect to see them?   I apologize if there’s any typos I’m doing speech to text on my iPhone.    
    • I've got a 2013 2500 6.0L Flexfuel. Drove the truck earlier today with no issues. Went to run an errand tonight and noticed key fob wouldn't work. Figured battery was dead, so replaced fob batter. Still wasn't working. Grabbed my other set of keys with the other fob and that one wasn't working either. So I manually unlock truck and insert key. Interior lights come on, dashboard lights up, turn key and truck starts. Turn truck off, like a moron, and try starting again. This time no crank, no click, no nothing. Lights still come on and dash lights up, but now I'm getting a service 4wheel drive, service tire monitor, etc. Check voltage on battery and Im showing 12.2v. Throw my battery charger on it and give it 15 mins and try starting again. But still no crank no start. Decide maybe its a bad battery, run to autozone grab a new one and put it in. Same issue. Disconnect battery and let it sit for 15 mins. Try again and still nothing. I had managed to roll the windows down earlier as its a humid night, but now I can't get them to roll up. Power locks are also not working now. Then randomly I try the key again, and it fires right up. Immediately I roll up the windows as we have nothing but rain forecast this week. I shut it back off wait 30 seconds and start up again. Worked a 2nd time. So turn it off, start putting things back together. Try one more time, and back to no crank no start. And now the car alarm starts going off. Had to disconnect battery and leave it that way for the night as I don't think my neighbors would appreciate my alarm going off again tonight. Any thoughts or help would be appreciated. 
    • No one will care for you like you care for you. Do what you can for as long as you can. IMHO of course. 
    • How about them NICKS!!! 
    • Hi there.  Long time lurker, first post.    i have read the previous posts regarding the water ingress problem with this emblem.  I bought my 1500 SLT the  summer of 2025 new and after reading the MANY problems with these emblems failing I decided to install one anyways.  As per a YouTube video, I sealed ( or tried to) this sign with silicone sealant around the outer perimeter joint and the holes that were already somewhat sealed on the rear plate of the emblem.  And installed the connector assembly using dielectric grease on the connectors. The installation looked great and worked well for about 4 months……then FAILURE.  Grrrrrr…… I live in the great white north and wash my truck weekly in an automatic car wash  to keep the salt off.  Let me tell you that removing the old, failed emblem is a whole different animal than removing the OEM individual letters without removing the grill assembly. Mainly because the illuminated logo is built differently than the original letters which  you can remove the red surface lettering with a knife or some kind of blade which gives access to the tabs which hold the logo onto the grill. So I had to essentially destroyed the old emblem to remove it. Doing so killed my chance of doing somekind of autopsy on the failed , old logo.  But there was plenty of water inside when I ripped it apart.  Prior to installing the new assembly I tried it with the old harness and it works fine.   Does anyone have any insight as to where the water is getting into this emblem? I intend to seal the new logo with slow curing epoxy this time around using a syringe.  I think this newer emblem may be an updated unit which I hope GM got the vendor to fix. It has an October 2025 date on it.    If this one  fails,  I am just going to revert back to the non-illuminated letters….AFTER PULLING THE GRILL.    Any thoughts on sealing with epoxy would be appreciated. Thx!   Doug  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...