Jump to content

Recommended Posts

Posted
On 3/19/2019 at 12:19 AM, Mozzer said:


 

 


They use some liquid with molasses & some other stuff round here (Vernon, British Columbia) when it isn't too cold. That stays on the road when put down before snowfall rather than flying off like the salt.

No idea what molasses do for rust though.emoji848.png



Sent from my Moto Z2 Play using Tapatalk
 

 

We just got a good rainfall the other day, it was badly needed to remove some of the salt residue on the roads. It looks like winter is almost over where I am, although you never know...last April 15th we got a few inches, and of course the road brime and salt stayed around until May.

 

I really am kind of on a quest to keep this truck "rust free", or close to it. How long I'll be on this kick I don't know. Lol. But right now I'm still hot on it. I'm actually excited to get under it and clean up some spots and apply another coat of protection. I think I'm getting really weird. I go through these fazes.

  • 3 months later...
Posted

I have a 2015. I live in MA, made a point of washing off salt during the winter months, didn't do much good,  29k on odometer frame is rusting, it's past the 3 year bumper to bumper so I guess I'm out of luck..

  • 2 weeks later...
Posted
On 6/27/2019 at 3:59 PM, jimlenk62 said:

I have a 2015. I live in MA, made a point of washing off salt during the winter months, didn't do much good,  29k on odometer frame is rusting, it's past the 3 year bumper to bumper so I guess I'm out of luck..

It's only cosmetic but i do agree it looks poor when it browns up and flakes off leaving rust patches. Gm has been this way since i started driving back in the early 90's, all my trucks after a couple years living in mass also have turned that way with the wax coating they have used for decades. One thing though at least i have never had a single issue with frame rot, rust yes but not rot thankfully.

  • 1 month later...
Posted

What does everyone do about winter prep for the trucks? The wax is slowly falling off of mine. So I was thinking of cleaning it then sealing it was a rust prevention chemical and then reapplying the wax again? Is that worth doing or is better to paint the areas of the frame I clean with actual paint?

Sent from my Pixel 2 XL using Tapatalk

Posted (edited)
10 hours ago, Rock1500 said:

What does everyone do about winter prep for the trucks? The wax is slowly falling off of mine. So I was thinking of cleaning it then sealing it was a rust prevention chemical and then reapplying the wax again? Is that worth doing or is better to paint the areas of the frame I clean with actual paint?

Sent from my Pixel 2 XL using Tapatalk
 

The wax is useless IMO.

 

If you prep and apply a protective coat (1000s of options), combined with spray on rust-inhibitor - I think you will have the best results. The rust-inhibitors can be wax based, or oil based. Some have negative results due to the oil in them, which tends to swell different types of rubbers. Hoses and grommets and bushings are places to avoid the oil-based ones.

 

The main points where the rust starts to form will be edges, bends, or the points where the lift contacts on the chassis. The tubular support going through each chassis rail is a very susceptible location.

 

You will not fully prevent rust, just slow the process. So dont get too frustrated with rust. It will be an ongoing process for the life of your vehicle. However, there are lots of ways to manage and reduce the rust, focus more on those!

Edited by tanner709
  • 2 weeks later...
Posted

I'm having this issue right now too. 2016 with 50k km. Thinking I'll just get the whole frame redone down the road. Surface rust won't hurt anything.

  • 1 month later...
Posted

GMC = RUST

Both bumpers had rust through ( from the inside out ) within a year of ownership.... dealer replaced both and told me I should have waxed it.

Had the frame wax recall treatment.... it lasted two years. found out it is a one time deal...... even if put on incorrectly.    You can see where the pads from the lift contacted the frame before it had set up.....   in a hurry ????

 

Posted
On 6/28/2018 at 5:53 PM, EnviroGreensolutions said:

You should be using Kryptonite Metal Treatment which is what GMC suggest you use for any corrosion, we are the only authorized product for it, we currently sell a bundle package with has the PurePrep + 3 cans Kryptonite you can purchase it on our website or on amazon.com

 

Best of luck!

EnvirogreenSolutions.com

That is what my dealer used......   it lasted 3 years and it is now peeling off......

They told me it was a one time treatment covered.... and now offered to use a rubberized undercoating    no charge.  

Any opinions ?

On 6/28/2018 at 5:53 PM, EnviroGreensolutions said:

 

 

Posted
6 hours ago, Whatever64 said:

That is what my dealer used......   it lasted 3 years and it is now peeling off......

They told me it was a one time treatment covered.... and now offered to use a rubberized undercoating    no charge.  

Any opinions ?

 

Stay away from rubberized undercoating that's all I can say on the matter.

Posted
On 10/23/2019 at 4:02 PM, High Country 6.2L/8 said:

Stay away from rubberized undercoating that's all I can say on the matter.

The dealer said rubberized and gave me the name Cal-Tex. On line it says it is " A paraffin-based material, our Rust Inhibitor keeps moisture from corroding inner body panels from the inside out. Not only does Rust Inhibitor help reduce rust and corrosion, but it also helps protect against salt and humidity. "

 

Posted
20 minutes ago, Whatever64 said:

The dealer said rubberized and gave me the name Cal-Tex. On line it says it is " A paraffin-based material, our Rust Inhibitor keeps moisture from corroding inner body panels from the inside out. Not only does Rust Inhibitor help reduce rust and corrosion, but it also helps protect against salt and humidity. "

 

I have something similar that dealer applied when new and apparently is GM approved whatever that means lol

Posted
What does everyone do about winter prep for the trucks? The wax is slowly falling off of mine. So I was thinking of cleaning it then sealing it was a rust prevention chemical and then reapplying the wax again? Is that worth doing or is better to paint the areas of the frame I clean with actual paint?

Sent from my Pixel 2 XL using Tapatalk


Some of us oil undercoat, speaking of which; I have to get done next week...

That's the only thing I've found that works in the salt belt...when I lived in the snow belt, I sprayed once a year; now I live just south of the snow belt and spray once every two years.

I have very little rust on my truck's frame and no rust on body panels, it's a 2012 with 170k miles.

Sent from my SM-G950U using Tapatalk

Posted
7 minutes ago, sdeeter19555 said:

Some of us oil undercoat, speaking of which; I have to get done next week...

That's the only thing I've found that works in the salt belt...when I lived in the snow belt, I sprayed once a year; now I live just south of the snow belt and spray once every two years.

I have very little rust on my truck's frame and no rust on body panels, it's a 2012 with 170k miles.

Sent from my SM-G950U using Tapatalk
 

Have a 17 dealer did the undercoating from new plus a rust module no rust yet and I live in Nova Scotia where there's lots of winter salt

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • I don't wanna do major surgery/upgrades, behind-the-dash work, add amps, change radio etc. on my '26 std cab WT. On the WT, it has the base 7" IOR infotainment setup, and only two speakers (doors). Since I listen to classical, looked around for speakers that do well and dug thru reviews. Two-way speakers were found to be better than 3-way. So I've ordered a pair of  Infinity Reference REF-9632IX 2 way speakers.  [These may  or may not have been discontinued / succeeded by the 3-way ...9633 ones.]    These speakers are lauded for 3 ohm and 94db sensitivity spec so they'll work well for ordinary base car radios without amps and offer better performance (quality,  strength) than  default base paper-cone speakers. They'll be installed in a few days and I'll let y'all know what I think. Bill W San Jose      
    • Thanks!   Changed out the rear shocks today to Bilstein 5100s.  So far feel much better. The stock Rancho were wore out.  Lots of heavy hauling (2 moves, home renovations, etc).  Next up is new BFG tires Monday.  Cant wait the current tires have little to no wet traction and are super loud (hum)    
    • Ok, I got the all the codes. What do you all think would be a place to start?
    • How about I just point to the factory pans stand pipe little drain plug and claim its a pan with a real drain plug !. I just couldn't swallow the fact that a Dorman pan which at this point is probably the only pan out there that fits the gas version truck cost that much up here in Canada so I decided initially anyway to skip it and see what I thought of pulling the pan method and down the road if I felt inclined enough then I would either install a drain plug kit in the factory pan if there is enough room for it, or have a bung welded onto it, or put an aftermarket pan on. The thing is if the pan is not pulled then the magnets in the pan can't be inspected and cleaned or if wanting to change out the filter. However of course it certainly would make the job easier to be able to drop the oil first before having to handle the pan if dropping the pan that go around was the goal.    I knew a guy locally that was doing custom field spraying years ago with a pickup pulling a ground driven sprayer, I believe it was a GM pickup with an automatic trans. He had a drain plug in his pan and would drop the oil out of it once a week and top it back up through the dipstick tube to keep refreshing a portion of the oil often and that made the transmission last far longer than had he done nothing. Soft fields pulling 500 gallons of water at the start of each mixed up sprayer tank batch and in low range sucking along. I imagine he got some tips from other custom sprayer outfits doing the same thing at the time and learning from their blown up tranny mistakes. Transmissions then had no lock up converter so would cook the crap out of the fluid slipping that much and it would not have been synthetic fluid either. 
    • 3.39 Kroger’s in Montgomery Texas. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...