SO..... Anyone install a lift kit yet? Pictures Please

[Northwestern]

Thanks.  Looks nice!  I'm going to call Les Schwab and have them install it.  I think that a 2 inch level kit should lift more than 1.25 inches.

[MTB10]

On 8/27/2019 at 8:15 AM, TheElementalCashew said:

6” BDS and 20x9 Fuel Rebels with 35” Nitto Ridge Grapplers. I need to do some coil overs on the front.

Are you running any spacers? 

 

Any rubbing? 

[TheElementalCashew]

Are you running any spacers? 
 
Any rubbing? 

No spacers.

There was a good deal of rubbing, and significant trimming required. The installer said it wasn’t difficult though, and that it may have been less with different tires.

[Stormtrouper]

CTB, 1.5" Motofab level, 3" rear blocks

[STX30MAC]

Before and after 6in BDS


Sent from my iPhone using Tapatalk

[Bluerado23]

Before and after 6in BDS


Sent from my iPhone using Tapatalk

Looks awesome!
No wheel spacers needed to retain the stock wheels ?

[STX30MAC]

Looks awesome!
No wheel spacers needed to retain the stock wheels

No spacers needed.
I want to go with some 20x9 with +0 offset but will probably have to trim more of the wheel wells.


Sent from my iPhone using Tapatalk

[jordanl010]

For all you DIY guys, where did you place your jack points? Pictures would help. I see the circular plates and read through the manual but its just side by side. Using a standard floor jack and research, not sure without an adapter, I can't seem to figure it out without trial and error on my new truck . 

[Chambo]

On 9/3/2019 at 4:37 PM, jordanl010 said:

For all you DIY guys, where did you place your jack points? Pictures would help. I see the circular plates and read through the manual but its just side by side. Using a standard floor jack and research, not sure without an adapter, I can't seem to figure it out without trial and error on my new truck . 

I wish someone would make a DIY video for a 4” or below. 

[eppieguy]

3” Rough Country running 285/55R22’s on OEM wheels

[SatinSilvy]

On 8/6/2019 at 1:02 AM, FirstAscent said:

Haha right!? I know what you mean.

UCA’s are not required at all, honestly for my purpose it’s purely aesthetics haha. The only off-road a little trail here and there driving up to the mountain or going camping etc, very tame!

But damn it looks good ha!

Awesome set up and this is what I’m looking to add to my truck. Any idea if you can run a stock wheel with 35’s with your current set up? I came across a killer deal on 295/65/20’s and would like to try and save a few bucks by running the stock wheels for a bit. 

[FirstAscent]

Awesome set up and this is what I’m looking to add to my truck. Any idea if you can run a stock wheel with 35’s with your current set up? I came across a killer deal on 295/65/20’s and would like to try and save a few bucks by running the stock wheels for a bit. 

Hey man thanks!

If I recall I think what would hold you back, with my exact setup, would be the 6” BDS Kit, I don’t remember if you can run the stock wheel with it, but I could be wrong, definitely check with them!

This is from BDS’s site:


35"x12.50" w/20x9 (Chevy) and 4.5"-5" back spacing
35"x12.50" w/20x9 (GMC) and 5.5"-6.25" back spacing

I have 20x10 wheels with the right back spacing, others have 20x12 working.

Let me know if I can help with anything else and good luck!

[yankeedoodle86]

Hey man thanks!

If I recall I think what would hold you back, with my exact setup, would be the 6” BDS Kit, I don’t remember if you can run the stock wheel with it, but I could be wrong, definitely check with them!

This is from BDS’s site:


35"x12.50" w/20x9 (Chevy) and 4.5"-5" back spacing
35"x12.50" w/20x9 (GMC) and 5.5"-6.25" back spacing

I have 20x10 wheels with the right back spacing, others have 20x12 working.

Let me know if I can help with anything else and good luck!

Stock wheels work fine with 35x12.50r20



Sent from my iPhone using Tapatalk

[SatinSilvy]

5 minutes ago, yankeedoodle86 said:

Stock wheels work fine with 35x12.50r20



Sent from my iPhone using Tapatalk

You’re the man thank you! Gonna go for a sleek stock look with extra height and a whole lot of extra performance for now. New wheels and tires in the spring. Thank you! 

[FirstAscent]

Stock wheels work fine with 35x12.50r20



Sent from my iPhone using Tapatalk

Thanks for the confirmation! BAM!